Display does not Dim when Light Control Switch is Turned ON
Circuit diagnosis · Vehicles built Aug 2013 – Jul 2014
Versions by build date: Aug 2013 – Jul 2014 from Aug 2014
INSPECTION PROCEDURE
| 1. CHECK IMAGE QUALITY SETTING |
 |
Display the "Display" screen.
Turn the light control switch to the tail or head position.
Check if "Day Mode" on the display adjustment screen is on.
- OK:
- "Day Mode" setting is off
|
NG |
 |
|
| TURN "Day Mode" SETTING OFF |
|
|
| OK |
|
 |
|
| 2. CHECK VEHICLE SIGNAL (OPERATION CHECK) |
 |
Enter the "Vehicle Signal Check Mode" screen. [Refer to Check Vehicle Signal in Operation Check (Click here)]
Check that the display for "TAIL" changes between ON and OFF according to the light control switch operation.
- OK:
Light Control Switch
|
Display
|
Tail or head
|
ON
|
Off
|
OFF
|
- HINT:
- This display is updated once per second. As a result, it is normal for the display to lag behind the actual switch operation.
Check that the display for "ADIM/TCAN" changes between DIM and BRIGHT according to the light control switch operation.
- OK:
Light Control Switch
|
Display
|
Tail or head
|
DIM
|
Off
|
BRIGHT
|
|
NG |
 |
|
| PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)
|
|
|
| OK |
|
 |
|
|