Circuit diagnosis · Vehicles built Aug 2013 – Jul 2014
Versions by build date: Aug 2013 – Jul 2014from Aug 2014
INSPECTION PROCEDURE
1. CHECK MULTI-DISPLAY
Check if there is any foreign matter caught between the display and exterior frame of the multi-display.
OK:
No foreign matter is caught between the display and exterior frame of the multi-display.
HINT:
If there is foreign matter between the display and exterior frame of the multi-display, the touch panel will remain pressed, preventing touch switch operation.
NG
REMOVE FOREIGN MATTER
OK
2. CHECK TOUCH PANEL
Check for foreign matter on the display.
OK:
The display is clean.
NG
CLEAN DISPLAY AND RECHECK TOUCH PANEL
OK
3. CHECK TOUCH SWITCH (OPERATION CHECK)
Enter the "Touch Switch Check" screen. Refer to Check Touch Switch in Operation Check (Click here).
Touch the display in the area where the switch malfunction occurs.
OK:
A "+" mark appears at the touched position.
NG
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)