B2624 Vehicles Speed Malfunction
Diagnostic trouble codes · Vehicles built Aug 2013 – Jul 2014
Versions by build date: Aug 2013 – Jul 2014 from Aug 2014
DESCRIPTION
The multiplex tilt and telescopic ECU forms a network with the ECUs of other systems through the CAN communication bus. Each ECU informs the other ECUs that it is connected to the network by outputting a specified signal (periodic signal) to the CAN communication bus on a regular schedule. The multiplex tilt and telescopic ECU receives vehicle speed signals from the combination meter via the CAN communication bus to prevent improper operation of the auto away/return function during driving.| DTC Code |
Detection Condition |
Trouble Area |
| B2624 |
Either condition is met:
|
|
- HINT:
- *: If the engine switch is turned off immediately after the vehicle comes to a sudden stop, the last vehicle speed signal may not be 0 km/h (0 mph).
INSPECTION PROCEDURE
| 1. CHECK OTHER DTC OUTPUT |
Check if DTC B2621 is output (Click here).
Result Result
Proceed to
DTC B2621 is not output.
A
DTC B2621 is output.
B
|
|
||||
| A | |
| 2. READ VALUE USING INTELLIGENT TESTER (FREEZE SPEED INFO) |
Use the Data List to check if the speed signal is functioning properly.
Tilt & Telescopic Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
Freeze Speed Info
Vehicle speed data/min.: 0 km/h (0 mph), max.: 255 km/h (158 mph)
Stop → Drive → Stop
0 km/h (0 mph) → Same speed as indicated on speedometer → 0 km/h (0 mph)
Result Result
Proceed to
Tester indication is normal.
A
Tester indication is abnormal.
B
- HINT:
- A vehicle speed of 3 km/h (2 mph) or more may be displayed on the intelligent tester screen immediately after the vehicle comes to a sudden stop. This is caused by a delay in the vehicle signal input via the CAN communication bus and is not a malfunction.
|
|
||||
| A | ||
| ||
