2013-2015 Land Cruiser Prado · Service Manual Drivetrain

REMOVAL

Removal / installation · Vehicles built from Aug 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
  1. After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).
  2. When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).


2. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY
  1. Remove the shift knob from the shift lever.


3. REMOVE CONSOLE PANEL SUB-ASSEMBLY
  1. Remove the rear console box (Click here).

  1. w/ Refrigerated Cool Box:
    Remove the rear console box (Click here).


4. REMOVE SHIFT LEVER BOOT ASSEMBLY

C215582
  1. Remove the 4 screws, 2 clips and shift lever boot.


5. REMOVE FLOOR SHIFT SHIFT LEVER ASSEMBLY

F051062
  1. Detach the shift lever cap boot from the manual transmission.

  1. C215583E01
    Cover the shift lever cap with a cloth.
    Text in Illustration 
    *1
    Cloth
    *a
    Down
    *b
    Counterclockwise

  1. While pressing down on the shift lever cap, turn it counterclockwise to remove the shift lever.

  1. Pull out the shift lever to remove it.


6. DRAIN MANUAL TRANSMISSION OIL
  1. Remove the drain plug and gasket, and then drain the manual transmission oil.

  1. Install a new gasket and the drain plug.

    Torque:
    37 N*m{ 377 kgf*cm , 27 ft.*lbf }


7. REMOVE FRONT EXHAUST PIPE ASSEMBLY
  1. Remove the front exhaust pipe (Click here).


8. REMOVE MANIFOLD STAY

  1. A221486
    Remove the 3 bolts and manifold stay.


9. REMOVE NO. 2 MANIFOLD STAY

  1. A222091
    Remove the 3 bolts and No. 2 manifold stay.


10. REMOVE PROPELLER SHAFT HEAT INSULATOR

C215584
  1. Remove the 2 bolts and propeller shaft heat insulator.


11. REMOVE TRANSFER CASE LOWER PROTECTOR
  1. Remove the 4 bolts and transfer case lower protector.


12. REMOVE FRONT PROPELLER SHAFT ASSEMBLY
  1. Remove the front propeller shaft (Click here).


13. REMOVE PROPELLER SHAFT ASSEMBLY
  1. Remove the propeller shaft (Click here).


14. REMOVE STARTER ASSEMBLY
  1. Remove the starter (Click here).


15. REMOVE NO. 1 CLUTCH HOUSING COVER

C215551
  1. Remove the 4 bolts and housing cover.


16. REMOVE CLUTCH RELEASE CYLINDER ASSEMBLY
  1. Remove the release cylinder (Click here).


17. REMOVE CLUTCH ACCUMULATOR ASSEMBLY
  1. Remove the clutch accumulator (Click here).


18. SUPPORT MANUAL TRANSMISSION WITH TRANSFER
  1. Support the manual transmission with a transmission jack.


19. REMOVE FRONT SUSPENSION MEMBER BRACKET LH

C215587
  1. Remove the 4 bolts and front suspension member bracket LH.


20. REMOVE FRONT SUSPENSION MEMBER BRACKET RH

C215588
  1. Remove the 4 bolts and front suspension member bracket RH.


21. REMOVE NO. 3 FRAME CROSSMEMBER SUB-ASSEMBLY
  1. Support the rear side of the transmission with a support stand.

  1. C215589
    Remove the 4 bolts from the No. 3 frame crossmember sub-assembly.

  1. C215590
    Remove the 4 nuts, 4 bolts and No. 3 frame crossmember sub-assembly.


22. REMOVE FRONT ENGINE MOUNTING INSULATOR RH

  1. C217744
    Remove the bolt and insulator.


23. REMOVE REAR NO. 1 ENGINE MOUNTING INSULATOR

  1. C215591
    Remove the 4 bolts and engine mounting insulator from the manual transmission.


24. DISCONNECT WIRE HARNESS

  1. C215592
    Disconnect the 2 connectors.

  1. Detach the 7 clamps.

  1. Disconnect the back-up light switch connector.

  1. Remove the bolt and disconnect the wire harness.


25. DISCONNECT TRANSFER AND MANUAL TRANSMISSION BREATHER HOSE SUB-ASSEMBLY

  1. C215593
    Detach the breather hose clamp.

  1. Disconnect the 4 breather hoses from the bracket and clutch housing.

  1. Disconnect the 2 breather hoses from the transfer adapter.


26. REMOVE MANUAL TRANSMISSION WITH TRANSFER
  1. Using a transmission jack, support the transmission.

  1. Remove the support stand from the transmission.

  1. C215594
    Remove the 9 bolts.

  1. Remove the manual transmission with transfer.


27. REMOVE TRANSMISSION UPPER COVER SUB-ASSEMBLY

C215595
  1. Remove the 2 bolts and upper cover.


28. REMOVE TRANSFER ASSEMBLY

  1. C233861E01
    for 1KD-FTV:
    Text in Illustration 
    *A
    for 1KD-FTV, RA61F
    *B
    for 1KD-FTV, A750F
    Remove the 8 bolts and 2 brackets.

  1. C235226
    except 1KD-FTV:
    Remove the 8 bolts and bracket.

  1. Remove the transfer from the transmission.

← REMOVAL (Aug 2013 – Jul 2014)INSTALLATION (Aug 2013 – Jul 2014) →