C0278 Open in ABS Solenoid Relay Circuit
Diagnostic trouble codes · Vehicles built from Aug 2014
Also covers:
- C0279 Short in ABS Solenoid Relay Circuit
Versions by build date: Aug 2013 – Jul 2014 from Aug 2014
DESCRIPTION
The solenoid relay is built into the master cylinder solenoid.This relay supplies power to each solenoid. If the initial check is OK, after the ignition switch is turned to ON, the relay turns on.
| DTC Code |
DTC Detection Condition |
Trouble Area |
| C0278 |
Either condition is met:
|
|
| C0279 |
The following condition continues for at least 0.2 seconds.
|
WIRING DIAGRAM
Refer to DTCs C0226, C0236, C0246, C0256, C1225, C1226, C1227 and C1228 (Click here).INSPECTION PROCEDURE
- NOTICE:
- When replacing the master cylinder solenoid, perform calibration (Click here).
- Inspect the fuses for circuits related to this system before performing the following inspection procedure.
- When replacing the master cylinder solenoid, perform calibration (Click here).
| 1. CHECK TERMINAL VOLTAGE (+BS) |
Disconnect the A7 skid control ECU connector.
Measure the voltage according to the value(s) in the table below.

- Standard Voltage:
Tester Connection
Condition
Specified Condition
A7-31 (+BS) - Body ground
Always
11 to 14 V
Text in Illustration *a
Front view of wire harness connector
(to Skid Control ECU)
|
|
||||
| OK | |
| 2. CHECK HARNESS AND CONNECTOR (GND1, GND2, AND GND3 TERMINAL) |
Disconnect the A7 and A8 skid control ECU connectors.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
A7-1 (GND1) - Body ground
Always
Below 1 Ω
A7-32 (GND2) - Body ground
Always
Below 1 Ω
A8-4 (GND3) - Body ground
Always
Below 1 Ω
|
|
||||
| OK | |
| 3. RECONFIRM DTC |
- HINT:
- These codes are stored when a problem is detected in the master cylinder solenoid.
- The solenoid relay is in the master cylinder solenoid.
- Therefore, solenoid relay circuit inspections and relay unit inspections cannot be performed. Be sure to check if any DTC is output before replacing the master cylinder solenoid.
Clear the DTCs (Click here).
Drive the vehicle at a speed of approximately 32 km/h (20 mph) or more for 60 seconds or more.
Check if the same DTCs are output (Click here).
- HINT:
- Reinstall the sensors, connectors, etc. and restore the previous vehicle conditions before rechecking for DTCs.
Result Result
Proceed to
DTC is not output
A
DTC is output (for LHD)
B
DTC is output (for RHD)
C
|
|
||||
|
|
||||
| A | ||
| ||
