2013-2015 Land Cruiser Prado · Service Manual Vehicle Interior

HOW TO PROCEED WITH TROUBLESHOOTING

Troubleshooting · Vehicles built Aug 2013 – Jul 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

HINT:
  1. Use these procedures to troubleshoot the engine immobiliser system.
  2. *: Use the intelligent tester.


1.VEHICLE BROUGHT TO WORKSHOP
    NEXT

    2.INSPECT BATTERY VOLTAGE

      Standard voltage:
      11 to 14 V

      If the voltage is below 11 V, recharge or replace the battery before proceeding.
    NEXT

    3.CRANK ENGINE FOR MORE THAN 10 SECONDS
      NEXT

      4.CHECK FOR DTC*
      1. Check for DTCs and note any codes that are output (Click here).

      2. Clear the DTCs (Click here).

      3. Recheck for DTCs. Try to duplicate the DTC (SFI system, ECD system and engine immobiliser system) by reproducing the symptoms indicated by the DTC.

        Result 
        Result
        Proceed to
        DTC is not output
        A
        SFI system DTC is output (for 2TR-FE)
        B
        SFI system DTC is output (for 1GR-FE)
        C
        ECD system DTC is output (5L-E)
        D
        ECD system DTC is output (1KD-FTV [w/ DPF])
        E
        ECD system DTC is output (1KD-FTV [w/o DPF])
        F
        Engine immobiliser system DTC is output
        G


      B.

      C.

      D.

      E.

      F.

      G.
      A

      5.PROBLEM SYMPTOMS TABLE
      1. Refer to Problem Symptoms Table (Click here).

        Result 
        Result
        Proceed to
        Fault is not listed in problem symptoms table
        A
        Fault is listed in problem symptoms table
        B


      B.
      A

      6.OVERALL ANALYSIS AND TROUBLESHOOTING*
      1. Data List / Active Test (Click here).

      2. Terminals of ECU (Click here).

      NEXT

      7.ADJUST, REPAIR OR REPLACE
        NEXT

        8.CONFIRMATION TEST
          NEXT

          ← SYSTEM DESCRIPTION (from Aug 2013)HOW TO PROCEED WITH TROUBLESHOOTING (from Aug 2014) →