HOW TO PROCEED WITH TROUBLESHOOTING
Troubleshooting · Vehicles built from Aug 2014
Versions by build date: Aug 2013 – Jul 2014 from Aug 2014
- HINT:
- Use these procedures to troubleshoot the engine immobiliser system.
- *: Use the intelligent tester.
- Use these procedures to troubleshoot the engine immobiliser system.
| 1.VEHICLE BROUGHT TO WORKSHOP |
| |||||
| 2.INSPECT BATTERY VOLTAGE |
- Standard voltage:
- 11 to 14 V
| |||||
| 3.CRANK ENGINE FOR MORE THAN 10 SECONDS |
| |||||
| 4.CHECK FOR DTC* |
Check for DTCs and note any codes that are output (Click here).
Clear the DTCs (Click here).
Recheck for DTCs. Try to duplicate the DTC (SFI system, ECD system and engine immobiliser system) by reproducing the symptoms indicated by the DTC.
Result Result
Proceed to
DTC is not output
A
SFI system DTC is output (for 2TR-FE)
B
SFI system DTC is output (for 1GR-FE)
C
ECD system DTC is output (5L-E)
D
ECD system DTC is output (1KD-FTV [w/ DPF])
E
ECD system DTC is output (1KD-FTV [w/o DPF])
F
Engine immobiliser system DTC is output
G
|
|||||
|
|||||
|
|||||
|
|||||
|
|||||
|
|||||
| |||||
| 5.PROBLEM SYMPTOMS TABLE |
Refer to Problem Symptoms Table (Click here).
Result Result
Proceed to
Fault is not listed in problem symptoms table
A
Fault is listed in problem symptoms table
B
|
|||||
| |||||
| 6.OVERALL ANALYSIS AND TROUBLESHOOTING* |
Data List / Active Test (Click here).
Terminals of ECU (Click here).
| |||||
| 7.ADJUST, REPAIR OR REPLACE |
| |||||
| 8.CONFIRMATION TEST |
| |||||