B1242 Wireless Door Lock Tuner Circuit Malfunction
Diagnostic trouble codes · Vehicles built Aug 2013 – Jul 2014
Versions by build date: Aug 2013 – Jul 2014 from Aug 2014
DESCRIPTION
The door control receiver receives signals from the transmitter and sends these signals to the main body ECU. This DTC is stored when the applicable RDA signal cannot be received within 1 second of the PRG signal being output from the main body ECU.| DTC Code |
DTC Detection Condition |
Trouble Area |
| B1242 |
The applicable RDA signal cannot be received within 1 second of the PRG signal being output from the main body ECU. |
|
WIRING DIAGRAM


INSPECTION PROCEDURE
- NOTICE:
- Inspect the fuses for circuits related to this system before performing the following inspection procedure.
- When replacing the door control receiver, refer to the registration procedures (Click here).
- Inspect the fuses for circuits related to this system before performing the following inspection procedure.
| 1. CLEAR DTC |
Clear the DTCs (Click here).
| NEXT | |
| 2. CHECK FOR DTC |
Check for DTCs (Click here).
- OK:
- DTC B1242 is not output.
|
|
||||
| OK | ||
| ||
| 3. CHECK DOOR CONTROL RECEIVER (DOOR CONTROL RECEIVER - MAIN BODY ECU) |
Disconnect the R26 receiver connector.
Disconnect the G64 ECU connector.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
R26-2 (RDA) - G64-26 (RDA)
Always
Below 1 Ω
R26-3 (PRG) - G64-25 (PRG)
R26-2 (RDA) or G64-26 (RDA) - Body ground
Always
10 kΩ or higher
R26-3 (PRG) or G64-25 (PRG) - Body ground
|
|
||||
| OK | |
| 4. CHECK HARNESS AND CONNECTOR (DOOR CONTROL RECEIVER - BATTERY AND BODY GROUND) |
Disconnect the R26 receiver connector.

Measure the resistance and voltage according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
R26-1 (GND) - Body ground
Always
Below 1 Ω
- Standard Voltage:
Tester Connection
Condition
Specified Condition
R26-5 (+B) - Body ground
Always
11 to 14 V
Text in Illustration *a
Front view of wire harness connector
(to Door Control Receiver)
|
|
||||
| OK | |
| 5. REPLACE DOOR CONTROL RECEIVER |
Temporarily replace the door control receiver with a new one.
- for 5 Door: (Click here).
- for 3 Door: (Click here).
- for 5 Door: (Click here).
Perform the registration procedures (Click here).
| NEXT | |
| 6. CLEAR DTC |
Clear the DTCs (Click here).
| NEXT | |
| 7. CHECK FOR DTC |
Check for DTCs (Click here).
- OK:
- DTC B1242 is not output.
|
|
||||
| OK | ||
| ||
