Removal / installation · Vehicles built Aug 2013 – Jul 2014
Versions by build date: Aug 2013 – Jul 2014from Aug 2014
1.
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).
Remove the bolt and disconnect the rear No. 1 seat outer belt floor anchor.
Detach the 6 claws and 2 guides and disconnect the rear seatback lock control lever base.
Remove the 4 bolts and 2 screws.
Detach the 5 clips and 8 claws.
Pass the rear seatback lock control lever base through the deck trim side panel and remove the deck trim side panel.
w/ Rear No. 2 Seat:
Remove the bolt and disconnect the rear No. 1 seat outer belt floor anchor.
Remove the bolt and disconnect the rear No. 2 seat outer belt floor anchor.
Remove the 2 bolts and 2 screws.
Detach the 4 clips and 8 claws and remove the deck trim side panel.
23.
REMOVE REAR QUARTER TRIM PANEL ASSEMBLY LH
w/o Rear No. 2 Seat:
Detach the 7 clips and 2 guides and remove the rear quarter trim panel.
w/ Rear No. 2 Seat:
Detach the 7 clips and 2 guides.
Detach the 4 clips and 2 guides, pass the rear No. 2 seat outer belt floor anchor through the rear quarter trim panel and remove the rear quarter trim panel.