2013-2015 Land Cruiser Prado · Service Manual Vehicle Exterior

Washer Fluid Level Warning Switch Circuit

Circuit diagnosis · Vehicles built from Aug 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

DESCRIPTION

When the volume of washer fluid decreases to below a certain level (when the level warning switch assembly is turned on), the multi-information display warns the driver by displaying a message*1 or the combination meter assembly warns the driver by displaying a washer fluid warning light*2.
  1. *1: w/ Multi-information Display
  2. *2: w/o Multi-information Display

WIRING DIAGRAM

E282042E02

INSPECTION PROCEDURE


1. READ VALUE USING INTELLIGENT TESTER (WASHER SWITCH)
  1. Use the Data List to check if the level warning switch assembly is functioning properly (Click here).

    Combination Meter 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Washer Switch
    Level warning switch / ON or OFF
    ON: Fluid volume is less than 550 to 750 cc (33.5 to 45.7 cu.in.)
    OFF: Fluid volume is more than 550 to 750 cc (33.5 to 45.7 cu.in.)
    -

    OK:
    On intelligent tester screen, item changes between ON and OFF according to above chart.



NG
Go to step 2
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)

2. INSPECT LEVEL WARNING SWITCH ASSEMBLY
  1. Remove the level warning switch assembly (Click here).

  1. Inspect the level warning switch assembly (Click here)



NG
REPLACE LEVEL WARNING SWITCH ASSEMBLY (Click here)
OK


3. INSPECT WASHER WIRING ASSEMBLY

  1. E210959E03
    Disconnect the A23 and B washer wiring assembly connectors.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    A23-3 (S) - B-1
    Always
    Below 1 Ω
    A23-6 (E) - B-2
    Always
    Below 1 Ω
    A23-3 (S) or B-1 - Body ground
    Always
    10 kΩ or higher
    A23-6 (E) or B-2 - Body ground
    Always
    10 kΩ or higher



NG
REPLACE WASHER WIRING ASSEMBLY
OK


4. CHECK HARNESS AND CONNECTOR (WASHER WIRING ASSEMBLY - COMBINATION METER ASSEMBLY AND BODY GROUND)
  1. Disconnect the A23 washer wiring assembly connector.

  1. Disconnect the G7 combination meter assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    A23-3 (S) - G7-20 (WLVL)
    Always
    Below 1 Ω
    A23-6 (E) - Body ground
    Always
    Below 1 Ω
    A23-3 (S) or G7-20 (WLVL) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE COMBINATION METER ASSEMBLY (Click here)


← Washer Fluid Level Warning Switch Circuit (Aug 2013 – Jul 2014)COMPONENTS (from Aug 2013) →