2013-2015 Land Cruiser Prado · Service Manual Audio / Visual / Telematics

HOW TO PROCEED WITH TROUBLESHOOTING

Troubleshooting · Vehicles built from Aug 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

HINT:
  1. Use the following procedure to troubleshoot the parking assist monitor system.
  2. *: Use the GTS.


1.VEHICLE BROUGHT TO WORKSHOP
    NEXT

    2.CUSTOMER PROBLEM ANALYSIS
    1. Ask the customer about the problems and the conditions at the time the malfunction occurred to make sure the problem symptom was not temporarily caused by radio waves in the surrounding environment.

      HINT:
      The parking assist monitor display may be temporarily distorted due to radio waves around the vehicle.

      Problem Symptom
      Cause
      1. Both of the following conditions are met:
        1. The problem symptom indicates a parking assist monitor display malfunction and the problem symptom cannot be reproduced.
        2. DTC C1622 is output as "Hist" only.*
      The display may be temporary distorted when the vehicle is close to an object that transmits radio waves, such as a telecommunication tower, an airport or a truck equipped with a transceiver.
      1. *: DTCs output as "Hist" will not be output again after DTCs are cleared.

    NEXT

    3.INSPECT BATTERY VOLTAGE
    1. Measure the battery voltage with the engine switch off.

      Standard Voltage:
      11 to 14 V

      If the voltage is below 11 V, replace or recharge the battery before proceeding to the next step.

    NEXT

    4.CHECK FOR DTC (NAVIGATION SYSTEM)*
    1. Check for DTCs and make a note of any codes that are output (Click here).

    2. Clear the DTCs (Click here).

    3. Recheck for DTCs. Try to prompt the DTC by simulating the original activity that the DTC suggests.

    4. Refer to the navigation system (Click here).

      HINT:
      The navigation receiver assembly may store the DTCs of the following system. If DTCs other than those specified in Diagnostic Trouble Code Chart of the parking assist monitor system are output, refer to Diagnostic Trouble Code Chart for the applicable system.

      Result:
      Result
      Proceed to
      No DTCs are output
      A
      DTCs are output
      B


    B.
    A

    5.CHECK COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM*
    1. Use the GTS to check if the CAN communication system is functioning normally (Click here).

      Result:
      Result
      Proceed to
      CAN DTCs are not output.
      A
      CAN DTCs are output.
      B


    B.
    A

    6.CHECK FOR DTC*
    1. Check for DTCs and note any codes that are output (Click here).

    2. Clear the DTCs (Click here).

    3. Recheck for DTCs. Try to prompt the DTC by simulating the original activity that the DTC suggests.

      Result:
      Result
      Proceed to
      No DTCs are output.
      A
      DTCs are output.
      B


    B.
    A

    7.PROBLEM SYMPTOMS TABLE
    1. Refer to the Problem Symptoms Table (Click here).

      Result:
      Result
      Proceed to
      Fault is not listed in Problem Symptoms Table
      A
      Fault is listed in Problem Symptoms Table
      B


    B.
    A

    8.OVERALL ANALYSIS AND TROUBLESHOOTING
    1. Diagnosis System (Click here)

    2. Terminals of ECU (Click here)

    3. Data List / Active Test (Click here)

    NEXT

    9.ADJUST, REPAIR OR REPLACE
      NEXT

      10.CONFIRMATION TEST
        NEXT

        ← HOW TO PROCEED WITH TROUBLESHOOTING (Aug 2013 – Jul 2014)INITIALIZATION (Aug 2013 – Jul 2014) →