INSTALLATION
Removal / installation · Vehicles built from Aug 2014
Versions by build date: Aug 2013 – Jul 2014 from Aug 2014
| 1. INSTALL REAR FLOOR SIDE AIRBAG SENSOR |
Check that the ignition switch is off.
Check that the cable is disconnected from the negative (-) battery terminal.
- CAUTION:
- Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
Install the rear floor airbag sensor with the bolt.
- Torque:
- 9.0 N*m{ 92 kgf*cm , 80 in.*lbf }
- NOTICE:
- If the rear floor airbag sensor has been dropped, or there are any cracks, dents or other defects in the case, bracket or connector, replace it with a new one.
- When installing the rear floor airbag sensor, be careful that the SRS wiring does not interfere with other parts and that it is not pinched between other parts.
- If the rear floor airbag sensor has been dropped, or there are any cracks, dents or other defects in the case, bracket or connector, replace it with a new one.
Check that the rear floor airbag sensor is not loose.
Connect the connector.
| 2. INSTALL REAR FLOOR SIDE AIRBAG SENSOR COVER |
Attach the clip and claw to install the cover.
Return the floor carpet to its original position.
| 3. INSTALL REAR DOOR SCUFF PLATE LH |
Attach the 3 clips, 6 claws and 2 guides to install the rear door scuff plate.
| 4. INSTALL REAR DOOR SCUFF PLATE RH |
- HINT:
- Use the same procedure described for the LH side.
| 5. INSTALL QUARTER SCUFF PLATE LH (w/ Rear No. 2 Seat) |
Install the quarter scuff plate with the 2 bolts.
| 6. INSTALL QUARTER SCUFF PLATE RH (w/ Rear No. 2 Seat) |
- HINT:
- Use the same procedure described for the LH side.
| 7. INSTALL REAR NO. 1 FLOOR STEP COVER (w/ Rear No. 2 Seat) |
- HINT:
- Use the same procedure for all rear No. 1 floor step covers.
Attach the 2 claws to install the rear No. 1 floor step cover.
| 8. INSTALL REAR NO. 1 SEAT ASSEMBLY |
for 60/40 Split Double-folding Seat Type LH Side:
Install the rear No. 1 seat assembly (Click here).
for 60/40 Split Double-folding Seat Type RH Side:
Install the rear No. 1 seat assembly (Click here).
for 60/40 Split Tumble Seat Type LH Side:
Install the rear No. 1 seat assembly (Click here).
for 60/40 Split Tumble Seat Type RH Side:
Install the rear No. 1 seat assembly (Click here).
for 60/40 Split Slide Walk-in Seat Type LH Side:
Install the rear No. 1 seat assembly (Click here).
for 60/40 Split Slide Walk-in Seat Type RH Side:
Install the rear No. 1 seat assembly (Click here).
| 9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
- NOTICE:
- When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).
| 10. CHECK SRS WARNING LIGHT |
Check the SRS warning light (Click here).
