2013-2015 Land Cruiser Prado · Service Manual Vehicle Interior

REMOVAL

Removal / installation · Vehicles built Aug 2013 – Jul 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:
  1. After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work. (Click here)
  2. When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).


2. REMOVE REAR NO. 1 SEAT ASSEMBLY
  1. for 60/40 Split Double-folding Seat Type LH Side:

    1. Remove the rear No. 1 seat assembly (Click here).

  1. for 60/40 Split Double-folding Seat Type RH Side:

    1. Remove the rear No. 1 seat assembly (Click here).

  1. for 60/40 Split Tumble Seat Type LH Side:

    1. Remove the rear No. 1 seat assembly (Click here).

  1. for 60/40 Split Tumble Seat Type RH Side:

    1. Remove the rear No. 1 seat assembly (Click here).

  1. for 60/40 Split Slide Walk-in Seat Type LH Side:

    1. Remove the rear No. 1 seat assembly (Click here).

  1. for 60/40 Split Slide Walk-in Seat Type RH Side:

    1. Remove the rear No. 1 seat assembly (Click here).


3. REMOVE REAR NO. 1 FLOOR STEP COVER (w/ Rear No. 2 Seat)

B238730E01

HINT:
Use the same procedure for all rear No. 1 floor step covers.

  1. Using a screwdriver, detach the 2 claws and remove the rear No. 1 floor step cover.

    HINT:
    Tape the screwdriver tip before use.

    Text in Illustration 
    *1
    Protective Tape


4. REMOVE QUARTER SCUFF PLATE LH (w/ Rear No. 2 Seat)

B238731
  1. Remove the 2 bolts and quarter scuff plate.


5. REMOVE QUARTER SCUFF PLATE RH (w/ Rear No. 2 Seat)

HINT:
Use the same procedure described for the LH side.


6. REMOVE REAR DOOR SCUFF PLATE LH

B238733E01
  1. Put protective tape around the rear door scuff plate.

  1. Using a screwdriver, detach the 3 clips, 6 claws and 2 guides and remove the rear door scuff plate.

    HINT:
    Tape the screwdriver tip before use.

    Text in Illustration 
    *1
    Protective Tape


7. REMOVE REAR DOOR SCUFF PLATE RH

HINT:
Use the same procedure described for the LH side.


8. REMOVE REAR FLOOR SIDE AIRBAG SENSOR COVER
  1. Fold back the floor carpet.

  1. B238364
    Detach the clip and claw and remove the cover.


9. REMOVE REAR FLOOR SIDE AIRBAG SENSOR

  1. B238365
    Remove the bolt and sensor.

  1. Disconnect the connector.

← ON-VEHICLE INSPECTION (from Aug 2014)REMOVAL (from Aug 2014) →