2013-2015 Land Cruiser Prado · Service Manual Audio / Visual / Telematics

C1611 ECU Malfunction

Diagnostic trouble codes · Vehicles built Aug 2013 – Jul 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

DESCRIPTION

This DTC is stored if the parking assist ECU judges that there is an internal malfunction as a result of its self check.

HINT:
The parking assist ECU stores different types of information during initialization. If the parking assist ECU cannot read the stored information when it is activated, the parking assist ECU judges that there is an internal malfunction and stores this DTC.

DTC Code
DTC Detection Condition
Trouble Area
C1611
  1. EEPROM Status (Initial read)
  2. AISIC Output Status
  1. Parking assist ECU initialization (not initialized parking assist ECU)
  2. Back camera position setting (initialized parking assist ECU)
  3. Side camera position setting (initialized parking assist ECU)
  4. Steering Angle setting (initialized parking assist ECU)
  5. Parking assist ECU

INSPECTION PROCEDURE

NOTICE:
  1. When "System initializing" is displayed on the parking assist ECU after the cable is disconnected from the negative (-) battery terminal, correct the steering angle neutral point (Click here).
  2. Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the parking assist monitor system may be needed (Click here).


1. READ VALUE USING GTS (PARKING ASSIST ECU STATUS)
  1. Use the Data List to check if the parking assist ECU status is functioning properly (Click here).

    Parking Assist Monitor System 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    EEPROM Status (Initial read)
    Parking assist ECU information / OK or NG
    OK: Parking assist ECU is normal
    NG: Parking assist ECU is abnormal
    -
    AISIC Output Status
    Output condition of camera display signal / OK or NG
    OK: Output condition of camera display signal is normal
    NG: Output condition of camera display signal is abnormal
    If "NG" is displayed, there is a malfunctions in parking assist ECU.
    Result 
    Result
    Proceed to
    OK is displayed for both items.
    A
    NG is displayed for EEPROM Status (Initial read).
    A
    NG is displayed for AISIC Output Status
    B



B
REPLACE PARKING ASSIST ECU (Click here)
A


2. SETTINGS (PARKING ASSIST ECU INITIALIZATION)

HINT:
  1. The parking assist ECU stores different types of information during initialization. If the parking assist ECU cannot read the stored information when it is activated, the parking assist ECU judges that there is an internal malfunction and stores this DTC.
  2. If the parking assist ECU cannot read the stored information when it is activated, allowing the ECU to store the information again may return the system to normal.

  1. Use the transition of diagnosis screens (note which transition pattern occurs) to confirm if the parking assist ECU was able to properly store the information from initialization (Click here).

    HINT:
    The procedure to make the parking assist ECU store the vehicle information differs when the parking assist ECU has stored the information (initialized) and when the information has not been stored (not initialized).

  1. Perform the following procedure depending on the memory conditions to register the vehicle information into the parking assist ECU.

    Condition
    Procedure
    Not initialized
    Parking assist ECU initialization (Click here)
    Initialized
    1. Back camera position setting (Click here)
    2. Steering angle setting (Click here)
    3. Side camera position setting (Click here )


NEXT


3. CHECK FOR DTC
  1. Clear the DTCs (Click here).

  1. Check for DTCs (Click here).

    OK:
    DTC C1611 is not output.

HINT:
  1. If DTC C1611 is output, perform the procedure to allow the parking assist ECU to store the vehicle information again.
  2. If DTC C1611 is still output after performing the procedure to make the parking assist ECU store the vehicle information 3 times, replace the parking assist ECU.
  3. If DTC C1611 is output frequently, replace the parking assist ECU even though the DTC is not output when rechecking for DTCs.

Result 
Proceed to
Result
OK
A
NG (for LHD)
B
NG (for RHD)
C


B
REPLACE PARKING ASSIST ECU (Click here)

C
REPLACE PARKING ASSIST ECU (Click here)
A

END (SETTINGS ARE DEFECTIVE)


← DIAGNOSTIC TROUBLE CODE CHART (from Aug 2014)C1611 ECU Malfunction (from Aug 2014) →