2013-2015 Land Cruiser Prado · Service Manual Vehicle Interior

C1A4A Skid Control Buzzer Circuit

Diagnostic trouble codes · Vehicles built from Aug 2013

DESCRIPTION

Based on pre-crash control, the driving support ECU warns the driver to be careful by sending a sounding signal to the skid control ECU to sound the skid control buzzer.
When the skid control ECU detects a malfunction in the skid control buzzer circuit, a malfunction signal is sent to the driving support ECU and a DTC is stored. Although the skid control ECU sends a malfunction signal to the driving support ECU, the relevant ABS DTCs are not stored.
DTC Code
DTC Detection Condition
Trouble Area
C1A4A
While the ignition switch is ON, a skid control buzzer circuit malfunction signal is received by the skid control ECU for 1 second.
  1. Skid control buzzer circuit
  2. Master cylinder assembly (Skid control ECU)
  3. Driving support ECU

INSPECTION PROCEDURE


1. PERFORM ACTIVE TEST USING INTELLIGENT TESTER
  1. Select the item below in the Active Test, and then check that the skid control buzzer sounds (Click here).

    ABS/VSC/TRC 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Buzzer
    Skid control buzzer
    ON/OFF
    -

    OK:
    Skid control buzzer sounds.



NG
GO TO VEHICLE STABILITY CONTROL SYSTEM (Click here)
OK


2. REPLACE MASTER CYLINDER SOLENOID (SKID CONTROL ECU)
  1. for LHD:Replace the master cylinder solenoid (Click here).

  1. for RHD:Replace the master cylinder solenoid (Click here).


NEXT


3. CHECK FOR DTC
  1. Clear the DTCs (Click here).

  1. Check for DTCs (Click here).

    OK:
    DTC C1A4A is not output.



NG
REPLACE DRIVING SUPPORT ECU (Click here)
OK

END (MASTER CYLINDER SOLENOID [SKID CONTROL ECU] IS DEFECTIVE)


← C1A47 Steering Angle Sensor (from Aug 2013)C1A4B Stop Light Relay Circuit (from Aug 2013) →