1.
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).
Use the same procedure for the other tonneau cover holder cap.
Using a screwdriver, detach the 2 claws and remove the tonneau cover holder cap.
HINT:
Tape the screwdriver tip before use.
Text in Illustration
*1
Protective tape
10.
REMOVE FRONT DECK SIDE TRIM COVER (w/ Tonneau Cover)
HINT:
Use the same procedure for the other front deck side trim cover.
Using a screwdriver, detach the 2 claws and remove the front deck side trim cover.
HINT:
Tape the screwdriver tip before use.
Text in Illustration
*1
Protective tape
11.
REMOVE QUARTER TRIM POCKET TRAY
Put protective tape around the quarter trim pocket tray.
Using a screwdriver, detach the 6 claws and 2 guides, and remove the quarter trim pocket tray.
HINT:
Tape the screwdriver tip before use.
Text in Illustration
*1
Protective tape
12.
REMOVE OUTER LAP BELT ANCHOR COVER
HINT:
Use the same procedure for the other outer lap belt anchor cover.
Detach the 3 claws and remove the outer lap belt anchor cover.
13.
REMOVE DECK TRIM SIDE PANEL ASSEMBLY LH
Remove the bolt and disconnect the front seat outer belt floor anchor.
Remove the bolt and disconnect the rear No. 1 seat outer belt floor anchor.
Remove the 3 bolts and 2 screws.
Detach the 9 claws and 12 clips and remove the deck trim side panel.
14.
REMOVE REAR QUARTER TRIM PANEL ASSEMBLY LH
Detach the 7 clips.
Detach the 4 claws and 2 guides, pass the rear No. 1 seat belt floor anchor through the rear quarter trim panel and remove the rear quarter trim panel.