1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
25800
2.REMOVE ELECTRIC EGR CONTROL VALVE ASSEMBLY (w/ EGR System)
Remove the electric EGR control valve assembly (See page Engine / Hybrid System>1KD-FTV (EMISSION CONTROL)>EGR VALVE>REMOVAL).
87245A
3.DISCONNECT INLET HEATER WATER HOSE (w/o EGR System)
25709E
4.DISCONNECT NO. 4 VACUUM TRANSMITTING PIPE SUB-ASSEMBLY (w/o EGR System)
17113E
5.REMOVE NO. 1 INTAKE PIPE (w/o EGR System)
22267A
6.REMOVE THROTTLE BODY BRACKET (w/o EGR System)
23701
7.REMOVE NO. 1, NO. 2 AND NO. 3 INJECTION PIPE SUB-ASSEMBLY (w/o EGR System)
17871A
8.REMOVE AIR CONNECTOR STAY (w/o EGR System)
9.DISCONNECT ENGINE WIRE (w/o EGR System)
26100G
10.REMOVE INTAKE AIR CONNECTOR WITH DIESEL THROTTLE BODY ASSEMBLY (w/o EGR System)
17118
11.REMOVE MANIFOLD STAY WITH VACUUM SWITCHING VALVE
Disconnect the vacuum switching valve connector.
w/o EGR System:
Disconnect the connector.
w/ EGR System without EGR Cooler:
Disconnect the 2 connectors.
w/ EGR System with EGR Cooler:
Disconnect the 3 connectors.
Disconnect the No. 1 vacuum transmitting hose.
w/ EGR System:
Disconnect the No. 2 vacuum transmitting hose and No. 3 vacuum transmitting hose.
w/ EGR Cooler:
Disconnect the No. 3 vacuum transmitting hose.
Disconnect the No. 3 vacuum transmitting hose and No. 4 vacuum transmitting hose.
| *A | w/o EGR System |
| *B | w/ EGR System |
Remove the 2 bolts and manifold stay with vacuum switching valve.
17138
12.REMOVE INTAKE PIPE OR HOSE STAY
Remove the bolt and intake pipe stay.
25804
13.REMOVE VACUUM CONTROL VALVE SET
Disconnect the 2 VSV connectors and 3 vacuum hoses.
Remove the 2 bolts and vacuum control valve set.
23704
14.REMOVE NO. 4 INJECTION PIPE SUB-ASSEMBLY
23770
15.REMOVE NO. 2 NOZZLE LEAKAGE PIPE ASSEMBLY
17118B
16.REMOVE INTAKE MANIFOLD INSULATOR
Remove the 2 bolts and intake manifold insulator.
17111
17.REMOVE INTAKE MANIFOLD
Detach the sensor wire connector clamp from the intake manifold.
| *1 | Sensor Wire |
Disconnect the vacuum hose from the intake manifold.
Remove the 2 nuts, 4 bolts, intake manifold and gasket.