Home › Suspension › SUSPENSION CONTROL › HEIGHT CONTROL DRYER › 2015.06–2020.08
RM27T0E _53 Suspension _053706 SUSPENSION CONTROL _0260874 HEIGHT CONTROL DRYER A

SUSPENSION CONTROL  HEIGHT CONTROL DRYER  INSTALLATION  


PROCEDURE

Hide 48950 1.INSTALL HEIGHT CONTROL DRYER ASSEMBLY

a.

Install a new O-ring.


b.

Install the height control dryer with the bolt.

Torque:
6.4 N*m (65 kgf*cm, 57 in.*lbf)


c.
C214866

Connect the No. 2 height control tube (See page Suspension>SUSPENSION CONTROL>SUSPENSION CONTROL SYSTEM (w/ Air Suspension)>PRECAUTION).

HINT:

For the connection procedure of the tube (type 2), refer to Precaution of the Suspension Control System section.



Hide 48910B 2.INSTALL HEIGHT CONTROL COMPRESSOR ASSEMBLY

a.

Install the height control compressor to the bracket with the 3 bolts.

Torque:
5.9 N*m (60 kgf*cm, 52 in.*lbf)


b.

Connect the connector.


c.

Attach the clamp.


d.

Attach the 3 clamps.


e.

Connect the connector.


f.

Attach the No. 2 height control tube.


Hide 52046A 6.INSTALL REAR BUMPER PROTECTOR SUB-ASSEMBLY LH (for 5 Door)

Hide 48978 7.INSTALL HEIGHT CONTROL COMPRESSOR COVER

Hide 76608 8.INSTALL REAR QUARTER PANEL MUDGUARD SUB-ASSEMBLY LH

Hide 10.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).