Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
47264D
1.TEMPORARILY INSTALL BRAKE MASTER CYLINDER PUSH ROD CLEVIS
Install the lock nut and brake master cylinder push rod clevis to the brake booster assembly.
Tighten the lock nut after adjusting the brake pedal height.
44785
2.INSTALL BRAKE BOOSTER GASKET
Install a new brake booster gasket to the brake booster assembly.
44610
3.INSTALL BRAKE BOOSTER ASSEMBLY
Install the brake booster assembly to the body with the 4 nuts.
Do not damage the brake lines.
44696
4.INSTALL CHECK VALVE GROMMET
Install a check valve grommet to the brake booster assembly.
44730
5.INSTALL BRAKE VACUUM CHECK VALVE ASSEMBLY
Install the vacuum check valve assembly to the brake booster assembly.
6.CONNECT VACUUM HOSE
Connect the vacuum hose with the clip.
47264A
7.INSTALL PUSH ROD PIN
47101A
8.INSTALL BRAKE PEDAL RETURN SPRING
47201
9.INSTALL BRAKE MASTER CYLINDER SUB-ASSEMBLY
Install the brake master cylinder sub-assembly (See page Brake>BRAKE SYSTEM (OTHER)>BRAKE MASTER CYLINDER>INSTALLATION).
31410
10.INSTALL CLUTCH MASTER CYLINDER ASSEMBLY (for RHD)
Install the clutch master cylinder assembly (See page Drivetrain>CLUTCH>CLUTCH MASTER CYLINDER (for RHD)>INSTALLATION).
11.CONNECT BRAKE TUBE CLAMP (for RHD)
Connect the 2 brake tube clamps to the body.
Install the brake tube to the clamps.
12.INSTALL AIR CLEANER CASE (for 2TR-FE RHD)
Install the air cleaner case (See page Engine / Hybrid System>2TR-FE (ENGINE MECHANICAL)>ENGINE ASSEMBLY>INSTALLATION).
17700
13.INSTALL AIR CLEANER CASE ASSEMBLY (for 5L-E RHD)
Install the air cleaner case assembly (See page Engine / Hybrid System>5L-E (ENGINE MECHANICAL)>ENGINE ASSEMBLY>INSTALLATION).
14.BLEED BRAKE SYSTEM
15.FILL RESERVOIR WITH BRAKE FLUID
16.BLEED CLUTCH LINE
17.CHECK FLUID LEVEL IN RESERVOIR
18.CHECK FOR BRAKE FLUID LEAK FROM CLUTCH LINE
19.CHECK AND ADJUST BRAKE PEDAL
Check and adjust the brake pedal (See page Brake>BRAKE SYSTEM (OTHER)>BRAKE PEDAL (for Vacuum Brake Booster)>ADJUSTMENT).