45203
1.CONNECT NO. 2 STEERING INTERMEDIATE SHAFT SUB-ASSEMBLY
Align the matchmarks on the No. 2 steering intermediate shaft and power steering gear.
Install the bolt.
45025D
2.INSTALL NO. 1 STEERING COLUMN HOLE COVER SUB-ASSEMBLY
Install the hole cover with the 4 bolts.
Do not fold back the boot part of the steering hole cover or extend it excessively. If it is extended excessively, return it to its original position.
45220
3.CONNECT STEERING INTERMEDIATE SHAFT ASSEMBLY
Align the matchmarks on the No. 2 steering intermediate shaft assembly and steering intermediate shaft assembly.
Install the steering intermediate shaft to the inside of the vehicle.
Install the bolt.
53737A
4.INSTALL NO. 1 FRONT FENDER APRON TO FRAME SEAL LH
45250
5.INSTALL STEERING COLUMN ASSEMBLY
Align the matchmarks on the steering intermediate shaft and steering column.
Install the steering column with the 4 nuts.
Install the bolt.
Attach the claws to connect the wire harness protector and wire harness.
55045
6.INSTALL INSTRUMENT LOWER PANEL FINISH PANEL SUB-ASSEMBLY (w/o Knee Airbag)
73900
7.INSTALL NO. 1 INSTRUMENT LOWER PANEL AIRBAG ASSEMBLY (w/ Knee Airbag)
89783
8.INSTALL TRANSPONDER KEY AMPLIFIER (Transponder Key)
9.INSTALL COMBINATION SWITCH ASSEMBLY WITH SPIRAL CABLE SUB-ASSEMBLY
Using pliers, grip the claws of the clamp and install the combination switch assembly with spiral cable sub-assembly to the steering column assembly with the clamp.
Connect the connectors to the combination switch with spiral cable.
45286B
10.INSTALL STEERING COLUMN UPPER COVER
Attach the claw to install the steering column upper cover.
Attach the 4 clips to install the steering column upper cover to the instrument cluster finish panel.
45287
11.INSTALL STEERING COLUMN LOWER COVER
Attach the 2 claws to install the steering column lower cover.
Install the 2 screws.
12.ADJUST SPIRAL CABLE SUB-ASSEMBLY
45100
13.INSTALL STEERING WHEEL ASSEMBLY
14.CHECK FRONT WHEELS FACING STRAIGHT AHEAD
15.INSTALL FRONT WHEEL LH
16.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
17.CHECK SRS WARNING LIGHT