Home › Audio / Visual / Telematics › AUDIO / VIDEO › AUDIO AND VISUAL SYSTEM (for Radio and Display Type) › 2015.06–2017.08
RM27T0E _56 Audio / Visual / Telematics _053720 AUDIO / VIDEO _0260969 AUDIO AND VISUAL SYSTEM(for Radio and Display Type) J

AUDIO / VIDEO  AUDIO AND VISUAL SYSTEM(for Radio and Display Type)  Steering Pad Switch Circuit  


DESCRIPTION

This circuit sends an operation signal from the steering pad switch assembly to the radio and display receiver assembly.

If there is an open in the circuit, the audio system cannot be operated using the steering pad switch assembly.

If there is a short in the circuit, the same condition as when the switch is continuously depressed occurs.

Therefore, the radio and display receiver assembly cannot be operated using the steering pad switch assembly, and the radio and display receiver assembly itself cannot function.

WIRING DIAGRAM

E286158E05
0.594,1.5 1.146,1.677 0.552,0.177 10 false Volume- 1.438,4.302 1.833,4.75 0.396,0.448 10 false Off Hook 0.604,4.375 1.021,4.615 0.417,0.24 10 false Voice 1.073,5.938 3.115,6.219 2.042,0.281 10 false Steering Pad Switch Assembly 2.219,4.281 2.615,4.688 0.396,0.406 10 false On Hook 1.271,1.521 1.875,1.698 0.604,0.177 10 false Volume+ 4.958,0.74 5.25,0.917 0.292,0.177 10 false AU1 4.969,2.531 5.271,2.708 0.302,0.177 10 false AU2 4.969,1.854 5.271,2.031 0.302,0.177 10 false EAU 6.302,0.833 6.677,1.01 0.375,0.177 10 false SW1 6.302,2.083 6.688,2.26 0.385,0.177 10 false SWG 6.302,2.74 6.677,2.917 0.375,0.177 10 false SW2 5.917,3.156 6.375,3.333 0.458,0.177 10 false H51 2.073,1.51 2.49,1.688 0.417,0.177 10 false Seek- 4.615,0.833 4.802,1.01 0.188,0.177 10 false z8 4.625,2.063 4.813,2.24 0.188,0.177 10 false z8 4.604,0.646 4.781,0.823 0.177,0.177 10 false 10 4.646,1.885 4.74,2.063 0.094,0.177 10 false 8 4.625,2.75 4.813,2.927 0.188,0.177 10 false z8 4.646,2.563 4.74,2.74 0.094,0.177 10 false 9 5.417,0.833 5.708,1.01 0.292,0.177 10 false G40 5.438,2.76 5.729,2.938 0.292,0.177 10 false G40 5.427,2.083 5.719,2.26 0.292,0.177 10 false G40 6.063,0.75 6.24,0.927 0.177,0.177 10 false 21 6.052,1.979 6.229,2.156 0.177,0.177 10 false 23 6.052,2.646 6.229,2.823 0.177,0.177 10 false 22 5.51,1.865 5.604,2.042 0.094,0.177 10 false 4 5.531,2.542 5.625,2.719 0.094,0.177 10 false 5 5.5,0.646 5.594,0.823 0.094,0.177 10 false 6 4.708,3.208 5.719,3.635 1.01,0.427 10 false Spiral Cable Sub-assembly 5.917,3.375 7.146,3.74 1.229,0.365 10 false Radio and Display Receiver Assembly 2.698,1.521 3.135,1.698 0.438,0.177 10 false Seek+ 0.844,5.281 2.76,5.552 1.917,0.271 10 false Steering Pad Switch RH Side 0.896,3.104 2.813,3.375 1.917,0.271 10 false Steering Pad Switch LH Side 2.646,2.396 3.354,2.573 0.708,0.177 10 false MODE

CAUTION / NOTICE / HINT

CAUTION:

The vehicle is equipped with an SRS (Supplemental Restraint System) which includes components such as airbags. Before servicing (including removal or installation of parts), be sure to read the precautionary notice for the SRS (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION).


PROCEDURE

1.INSPECT STEERING PAD SWITCH ASSEMBLY
a.

Remove the steering pad switch assembly (See page Steering>STEERING COLUMN>STEERING WHEEL>REMOVAL).


b.

Inspect the steering pad switch assembly (See page Steering>STEERING COLUMN>STEERING WHEEL>INSPECTION).



OK

2.INSPECT SPIRAL CABLE SUB-ASSEMBLY

NG

REPLACE STEERING PAD SWITCH ASSEMBLY

2.INSPECT SPIRAL CABLE SUB-ASSEMBLY
a.

Remove the spiral cable sub-assembly (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>SPIRAL CABLE>REMOVAL).


b.

Inspect the spiral cable sub-assembly (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>SPIRAL CABLE>INSPECTION).



OK

3.CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - SPIRAL CABLE SUB-ASSEMBLY)

NG

REPLACE SPIRAL CABLE SUB-ASSEMBLY

3.CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - SPIRAL CABLE SUB-ASSEMBLY)
a.

Disconnect the H51 radio and display receiver assembly connector.


b.

Disconnect the G40 spiral cable sub-assembly connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
H51-21 (SW1) - G40-6 (AU1) Always Below 1 Ω
H51-22 (SW2) - G40-5 (AU2) Always Below 1 Ω
H51-23 (SWG) - G40-4 (EAU) Always Below 1 Ω
H51-21 (SW1) - Body ground Always 10 kΩ or higher
H51-22 (SW2) - Body ground Always 10 kΩ or higher
H51-23 (SWG) - Body ground Always 10 kΩ or higher




OK

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR