The power management control ECU and steering lock actuator (steering lock ECU) are connected by a cable and the LIN communication line. This DTC is stored when the steering lock position signal information from the cable and the steering lock position signal information from the LIN communication line are inconsistent.
When the power management control ECU is replaced with a new one and the cable is connected to the negative (-) battery terminal, the power source mode is reset to on (IG). When the battery is removed and reinstalled, the power source mode that was selected when the battery was removed is restored.
| DTC Code | DTC Detection Condition | Trouble Area |
|---|---|---|
| B2285 | The steering lock position signal information from the cable and the steering lock position signal information from the LIN communication line are inconsistent. | ·
AM2 fuse ·
Steering lock actuator assembly (steering lock ECU) ·
Power management control ECU ·
LIN communication system ·
Harness or connector |
When using the intelligent tester with the engine switch off to troubleshoot: Connect the intelligent tester to the vehicle and turn a courtesy light switch on and off at 1.5 second intervals until communication between the intelligent tester and vehicle begins.
Before performing the inspection, check that there are no problems related to the CAN communication system and LIN communication system.
Inspect the fuses for circuits related to this system before performing the following inspection procedure.
After replacing the steering lock actuator assembly (steering lock ECU), perform key ID code registration. Refer to the Service Bulletin for the registration procedure.
Check for DTCs (See page Vehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>ENTRY AND START SYSTEM (for Start Function)>DTC CHECK / CLEAR).
LIN communication system DTCs B2287 and B2785 are not output simultaneously.
OK
NG
OK
NG
OK
NG
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G35-4 (SLP1) - Body ground | Steering lock locked | 10 kΩ or higher |
| G35-4 (SLP1) - Body ground | Steering lock released | Below 1 Ω |
| *a | Component with harness connected
(Steering Lock ECU) |
| Result | Proceed to | |
|---|---|---|
| OK | A | |
| NG | for Manual Tilt and Manual Telescopic Steering Column | B |
| for Power Tilt and Power Telescopic Steering Column | C | |
A
B
C
Disconnect the G51 power management control ECU connector.
Disconnect the G35 steering lock ECU connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G51-3 (SLP) - G35-4 (SLP1) | Always | Below 1 Ω |
| G51-3 (SLP) or G35-4 (SLP1) - Body ground | Always | 10 kΩ or higher |
OK
NG
Connect the intelligent tester to the DLC3.
Turn the engine switch on (IG).
Turn the intelligent tester on.
Enter the following menus: Body / Power Source Control / Data List.
According to the display on the intelligent tester, read the Data List.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
|---|---|---|---|
| Steering Unlock Switch | Steering lock condition / ON or OFF | ON: Steering lock released (Engine switch on [ACC])
OFF: Steering lock locked (Engine switch off) |
- |
ON (steering lock released) or OFF (steering lock locked) appears on the screen according to the steering lock condition.
| Result | Proceed to | |
|---|---|---|
| NG | A | |
| OK | for Manual Tilt and Manual Telescopic Steering Column | B |
| for Power Tilt and Power Telescopic Steering Column | C | |
A
B
C