Home › Vehicle Interior › HEATING / AIR CONDITIONING › COMPRESSOR (for 2TR-FE) › 2015.06–2020.08
RM27T0E _58 Vehicle Interior _053739 HEATING / AIR CONDITIONING _0261181 COMPRESSOR(for 2TR-FE) A

HEATING / AIR CONDITIONING  COMPRESSOR(for 2TR-FE)  INSTALLATION  


PROCEDURE

Hide 1.ADJUST COMPRESSOR OIL

a.

When replacing the compressor and magnet clutch with a new one, gradually discharge the refrigerant gas from the service valve and drain the following amount of oil from the new compressor and magnet clutch before installation.

Standard:

for Single Air Conditioning System:

(The amount of oil inside a new cooler compressor: 120 to 135 cc (4.1 to 4.6 fl. oz.)) - (The amount of oil remaining in the removed cooler compressor) = (The amount of oil to be removed when replacing the compressor)


Standard:

for Dual Air Conditioning System:

(The amount of oil inside a new cooler compressor: 180 to 195 cc (6.1 to 6.6 fl. oz.)) - (The amount of oil remaining in the removed cooler compressor) = (The amount of oil to be removed when replacing the compressor)


NOTICE:
·

When checking the compressor oil level, follow the A/C system precautions.

·

Since compressor oil remains in the pipes of the vehicle, if a new compressor is installed without removing some oil from the compressor, the oil amount becomes excessive. Excessive oil prevents heat exchange in the refrigerant cycle and causes refrigeration system failure.

·

If the volume of oil remaining in the removed compressor and magnet clutch is small, check for oil leakage.

·

Be sure to use ND-OIL 8 or equivalent compressor oil.




Hide 88320 2.INSTALL COOLER COMPRESSOR ASSEMBLY

a.
E326342E02
2.833,0.396 3.052,0.604 0.219,0.208 10 false (1) 3.063,1.031 3.281,1.24 0.219,0.208 10 false (2) 2.802,1.063 3.021,1.271 0.219,0.208 10 false (3) 3.156,0.313 3.375,0.521 0.219,0.208 10 false (4)

Install the compressor with the 4 bolts and tighten the bolts in the order shown in the illustration.

Torque:
25 N*m (255 kgf*cm, 18 ft.*lbf)


b.

Connect the connector.


Hide 88704 3.INSTALL SUCTION HOSE SUB-ASSEMBLY

a.

Remove the vinyl tape attached to the hose.


b.

Sufficiently apply compressor oil to a new O-ring and the fitting surface of the compressor.

Compressor oil:

ND-OIL 8 or equivalent



c.

Install the O-ring to the suction hose.


d.

Connect the suction hose with the bolt.

Torque:
9.8 N*m (100 kgf*cm, 87 in.*lbf)


Hide 88703 4.INSTALL DISCHARGE HOSE SUB-ASSEMBLY

a.

Remove the vinyl tape attached to the hose.


b.

Sufficiently apply compressor oil to a new O-ring and the fitting surface of the compressor.

Compressor oil:

ND-OIL 8 or equivalent



c.

Install the O-ring to the discharge hose.


d.

Connect the discharge hose with the bolt.

Torque:
9.8 N*m (100 kgf*cm, 87 in.*lbf)


Hide 51405A 11.INSTALL NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY

Hide 52129B 12.INSTALL FRONT BUMPER COVER LOWER