Home › Vehicle Interior › HEATING / AIR CONDITIONING › VISCOUS HEATER MAGNET CLUTCH(for 1KD-FTV) › 2015.06–2020.08
RM27T0E _58 Vehicle Interior _053739 HEATING / AIR CONDITIONING _0261193 VISCOUS HEATER MAGNET CLUTCH(for 1KD-FTV) A

HEATING / AIR CONDITIONING  VISCOUS HEATER MAGNET CLUTCH(for 1KD-FTV)  INSTALLATION  


PROCEDURE

Hide 87101 1.INSTALL NO. 1 VISCOUS HEATER BRACKET SUB-ASSEMBLY

Hide 87120G 2.INSTALL VISCOUS WITH MAGNET CLUTCH HEATER ASSEMBLY

a.

Install the viscous with magnet clutch heater assembly with the 2 bolts.

Torque:
45 N*m (459 kgf*cm, 33 ft.*lbf)


b.

Connect the water by-pass hose and water hose.


c.

Using pliers, grip the claws of the clips and slide the 2 clips.


d.

Connect the viscous heater connector.


Hide 16361A 3.INSTALL FAN AND GENERATOR V BELT

a.

Install the fan and generator V belt (See page Engine / Hybrid System>1KD-FTV (ENGINE MECHANICAL)>DRIVE BELT>INSTALLATION).


b.

Install the front heater bracket with the 2 bolts.

Torque:
25 N*m (255 kgf*cm, 18 ft.*lbf)


Hide 17801 6.INSTALL AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY

Hide 74431 9.INSTALL BATTERY TRAY

Hide 28800 10.INSTALL BATTERY

Hide 16470 12.INSTALL RADIATOR RESERVOIR

a.

Connect the No. 2 water by-pass hose to the radiator reservoir.


b.

Connect the No. 1 water by-pass hose to the fan shroud and attach the 2 clamps.


c.

Install the radiator reservoir assembly with the 3 bolts.

Torque:
5.0 N*m (51 kgf*cm, 44 in.*lbf)


Hide 51405A 14.INSTALL NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY

Hide 15.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 53292A 17.INSTALL UPPER RADIATOR SUPPORT SEAL