Before beginning this procedure, make sure that the rear air conditioning FOOT mode functions are not operating.
53292A
1.REMOVE UPPER RADIATOR SUPPORT SEAL
2.RECOVER REFRIGERANT FROM REFRIGERATION SYSTEM
for HFC-134a (R134a):
Click hereVehicle Interior>HEATING / AIR CONDITIONING>REFRIGERANT (for HFC-134a(R134a))>REPLACEMENT
for HFO-1234yf (R1234yf):
Click hereVehicle Interior>HEATING / AIR CONDITIONING>REFRIGERANT(for HFO-1234yf(R1234yf))>REPLACEMENT
3.DRAIN ENGINE COOLANT
for 1GR-FE:
Drain the engine coolant (See page Engine / Hybrid System>1GR-FE (COOLING)>COOLANT>REPLACEMENT).
for 2TR-FE:
Drain the engine coolant (See page Engine / Hybrid System>2TR-FE (COOLING)>COOLANT>REPLACEMENT).
for 1KD-FTV:
Drain the engine coolant (See page Engine / Hybrid System>1KD-FTV (COOLING)>COOLANT>REPLACEMENT).
for 5L-E:
Drain the engine coolant (See page Engine / Hybrid System>5L-E (COOLING)>COOLANT>REPLACEMENT).
for 1GD-FTV:
Drain the engine coolant (See page Engine / Hybrid System>1GD-FTV (COOLING)>COOLANT>REPLACEMENT).
4.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work. (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION)
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
5.REMOVE REAR NO. 2 SEAT ASSEMBLY
for Manual Seat:
Remove the rear No. 2 seat assembly (See page Vehicle Interior>SEAT>REAR NO. 2 SEAT ASSEMBLY (for Manual Seat Type LH Side)>REMOVAL).
for Power Seat:
Remove the rear No. 2 seat assembly (See page Vehicle Interior>SEAT>REAR NO. 2 SEAT ASSEMBLY (for Power Seat Type LH Side)>REMOVAL).
for Face to Face Seat Type:
Remove the rear No. 2 seat assembly (See page Vehicle Interior>SEAT>REAR NO. 2 SEAT ASSEMBLY(for Face to Face Seat Type)>REMOVAL).
6.REMOVE REAR NO. 1 SEATBACK ASSEMBLY
for 60/40 Split Double-folding Seat Type LH Side:
Remove the rear No. 1 seatback assembly (See page Vehicle Interior>SEAT>REAR NO. 1 SEAT ASSEMBLY (for 60/40 Split Double-folding Seat Type LH Side)>REMOVAL).
for 60/40 Split Double-folding Seat Type RH Side:
Remove the rear No. 1 seatback assembly (See page Vehicle Interior>SEAT>REAR NO. 1 SEAT ASSEMBLY (for 60/40 Split Double-folding Seat Type RH Side)>REMOVAL).
58371F
7.REMOVE REAR NO. 1 FLOOR STEP COVER (w/ Rear No. 2 Seat)
67933
8.REMOVE QUARTER SCUFF PLATE RH (w/ Rear No. 2 Seat)
67917C
9.REMOVE REAR DOOR SCUFF PLATE RH
62331C
10.REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP RH
73233
11.REMOVE OUTER LAP BELT ANCHOR COVER
64910M
12.REMOVE TONNEAU COVER ASSEMBLY (w/ Tonneau Cover)
64717A
13.REMOVE FRONT LUGGAGE COMPARTMENT TRIM COVER (w/o Rear No. 2 Seat)
58401A
14.REMOVE NO. 1 DECK BOARD SUB-ASSEMBLY (w/o Rear No. 2 Seat)
58574A
15.REMOVE REAR FLOOR MAT REAR SUPPORT PLATE (w/o Rear No. 2 Seat)
57412C
16.REMOVE FLOOR SIDE RAIL LH (w/ Deck Rail)
57411D
17.REMOVE FLOOR SIDE RAIL RH (w/ Deck Rail)
58570C
18.REMOVE REAR FLOOR CARPET ASSEMBLY (w/o Rear No. 2 Seat)
73233A
19.REMOVE REAR NO. 1 SEAT OUTER LAP BELT ANCHOR COVER
64725D
20.REMOVE NO. 1 LUGGAGE COMPARTMENT TRIM HOOK (w/o Rear No. 2 Seat)
64937A
21.REMOVE NO. 1 TONNEAU COVER HOLDER CAP (w/o Tonneau Cover)
64712F
22.REMOVE FRONT DECK SIDE TRIM COVER RH (w/ Tonneau Cover)
74617A
23.REMOVE ASSIST GRIP PLUG (w/ Rear No. 2 Seat)
74603C
24.REMOVE ASSIST GRIP SUB-ASSEMBLY (w/ Rear No. 2 Seat)
64730B
25.REMOVE DECK TRIM SIDE PANEL ASSEMBLY RH
62630P
26.REMOVE REAR QUARTER TRIM PANEL ASSEMBLY RH
88710A
27.DISCONNECT AIR CONDITIONING TUBE AND ACCESSORY ASSEMBLY
Remove the bolt.
Disconnect the air conditioning tube and accessory assembly.
Do not use a screwdriver or similar tool to disconnect the tube.
Seal the openings of the disconnected parts using vinyl tape to prevent moisture and foreign matter from entering them.
Remove the 2 O-rings from the air conditioning tube and accessory assembly.
Using pliers, grip the claws of the clips and slide the 2 clips.
Disconnect the heater water inlet hose and heater water outlet hose.
87217E
28.REMOVE REAR SIDE NO. 2 AIR DUCT
Detach the 2 clips.
Detach the clamp and remove the duct.
87217F
29.REMOVE REAR SIDE NO. 3 AIR DUCT
Detach the 2 clips and remove the duct.
87217D
30.REMOVE REAR SIDE NO. 1 AIR DUCT
Detach the 2 claws and remove the cooler plate.
Swing the bottom of the duct sideways and remove the duct.
87030A
31.REMOVE REAR COOLING UNIT ASSEMBLY
Disconnect the 3 connectors and detach the 3 clamps.
Remove the 5 bolts and rear cooling unit.
62170A
32.REMOVE CURTAIN SHIELD AIRBAG ASSEMBLY RH
88566V
33.REMOVE REAR ROOF NO. 5 AIR DUCT
Detach the clip and remove the duct.
88566U
34.REMOVE REAR ROOF NO. 4 AIR DUCT
Detach the clip and remove the duct.
88566T
35.REMOVE REAR ROOF NO. 3 AIR DUCT
Detach the clip and remove the duct.
88566S
36.REMOVE REAR ROOF NO. 2 AIR DUCT
Detach the clip and remove the duct.
88566R
37.REMOVE REAR ROOF NO. 1 AIR DUCT
Detach the 4 clips and remove the duct.