Home › Steering › STEERING COLUMN › STEERING COLUMN ASSEMBLY (for Manual Tilt and Manual Telescopic Steering Column) › 2017.08–2020.08
RM27T0E _55 Steering _053718 STEERING COLUMN _0260957 STEERING COLUMN ASSEMBLY(for Manual Tilt and Manual Telescopic Steering Column) A

STEERING COLUMN  STEERING COLUMN ASSEMBLY(for Manual Tilt and Manual Telescopic Steering Column)  REMOVAL  


CAUTION / NOTICE / HINT

CAUTION:

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing the steering wheel (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION).


HINT:
·

Use the same procedure for RHD and LHD vehicles.

·

The procedure listed below is for LHD vehicles.



PROCEDURE

Hide 1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:
·

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).

·

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).



Hide 2.PLACE FRONT WHEELS FACING STRAIGHT AHEAD

Hide 3.REMOVE FRONT WHEEL LH

Hide 45100 4.REMOVE STEERING WHEEL ASSEMBLY

Hide 45287 5.REMOVE STEERING COLUMN LOWER COVER

a.
C384101

Remove the 2 screws.


b.

Detach the 2 claws and remove the steering column lower cover.


Hide 45286B 6.REMOVE STEERING COLUMN UPPER COVER

a.
C384102

Detach the 4 clips.


b.

Detach the claw and remove the steering column upper cover.


Hide 7.REMOVE COMBINATION SWITCH ASSEMBLY WITH SPIRAL CABLE SUB-ASSEMBLY

a.

Disconnect the connectors from the combination switch with spiral cable.


b.
C384103

Use pliers to hold the clamp and raise the claw with a screwdriver. Then remove the combination switch assembly with spiral cable sub-assembly from the steering column assembly.


Hide 89783 8.REMOVE TRANSPONDER KEY AMPLIFIER (w/ Transponder Key)

Hide 55045 9.REMOVE INSTRUMENT LOWER PANEL FINISH PANEL SUB-ASSEMBLY (w/o Knee Airbag)

Hide 73900 10.REMOVE NO. 1 INSTRUMENT LOWER PANEL AIRBAG ASSEMBLY (w/ Knee Airbag)

Hide 45250 11.REMOVE STEERING COLUMN ASSEMBLY

a.

Detach the claws and remove the wire harness protector and wire harness.


b.
C217163E03
1.677,1.042 2.073,1.625 2.073,1.625 2.542,1.625 true 1.677,0.969 2.26,1.625 true 2.646,1.521 3.104,1.823 0.458,0.302 10 true *a

Put matchmarks on the steering intermediate shaft and steering column.

Text in Illustration
*a Matchmark


c.

Remove the bolt.


d.
C384104

Remove the 4 nuts and steering column.


Hide 53737A 12.REMOVE NO. 1 FRONT FENDER APRON TO FRAME SEAL LH

Hide 45220 13.DISCONNECT STEERING INTERMEDIATE SHAFT ASSEMBLY

a.
C215850E08
2.208,0.844 2.521,1.698 2.521,1.698 2.917,1.698 true 2.292,0.76 2.771,1.698 true 2.927,1.604 3.292,1.854 0.365,0.25 10 true *a

Put matchmarks on the steering intermediate shaft and No. 2 steering intermediate shaft.

Text in Illustration
*a Matchmark


b.

Remove the bolt, and then pull out the intermediate shaft toward the inside of the vehicle.


Hide 45025D 14.REMOVE NO. 1 STEERING COLUMN HOLE COVER SUB-ASSEMBLY

a.
C215852

Remove the 4 bolts and steering column hole cover from the vehicle.


Hide 45203 15.DISCONNECT NO. 2 STEERING INTERMEDIATE SHAFT SUB-ASSEMBLY

a.
U148518E01
2.125,1.214 1.411,0.308 false 1.05,0.206 1.491,0.521 0.441,0.314 10 *a

Put matchmarks on the No. 2 steering intermediate shaft and power steering gear.

Text in Illustration
*a Matchmark


b.

Remove the bolt and No. 2 steering intermediate shaft from the power steering gear.