When the glass breakage sensor detects that the quarter window glass* or back door glass is tapped or broken, the sensor will set off the alarm for 30 seconds.
*: for 5 Door
for 3 Door:
for 5 Door:
w/ Entry and Start System:
If the main body ECU (multiplex network body ECU) is replaced, refer to the Service Bulletin.
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Body Electrical / Main Body / Data List.
According to the display on the GTS, read the Data List.
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| Sealed Glas Brak Sen | Glass breakage sensor connecting | With or Without | With: Glass breakage sensor operating
Without: Glass breakage sensor not operating |
- |
"With" (glass breakage sensor operating) appears on GTS screen.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
*1: for 5 Door
*2: w/ Glass Hatch Opener System
*3: w/o Glass Hatch Opener System
Disconnect the G218 main body ECU (multiplex network body ECU) connector.
Disconnect the R25 quarter window assembly LH (glass breakage sensor) connector.*1
Disconnect the Q20 quarter window assembly RH (glass breakage sensor) connector.*1
Disconnect the Y2*2 or X8*3 back door glass (glass breakage sensor) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G218-7 (GPBS) - Y2-3 (SSR+) | Always | Below 1 Ω |
| Y2-1 (E) - Body ground | Always | Below 1 Ω |
| G218-7 (GPBS) or Y2-3 (SSR+) - Other terminals and body ground | Always | 10 kΩ or higher |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G218-7 (GPBS) - X8-2 (SSR+) | Always | Below 1 Ω |
| X8-1 (E) - Body ground | Always | Below 1 Ω |
| G218-7 (GPBS) or X8-2 (SSR+) - Other terminals and body ground | Always | 10 kΩ or higher |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G218-7 (GPBS) - R25-1 (SSR+) | Always | Below 1 Ω |
| R25-2 (SSR-) - Q20-1 (SSR+) | Always | Below 1 Ω |
| Q20-2 (SSR-) - Y2-3 (SSR+) | Always | Below 1 Ω |
| Y2-1 (E) - Body ground | Always | Below 1 Ω |
| G218-7 (GPBS) or R25-1 (SSR+) - Other terminals and body ground | Always | 10 kΩ or higher |
| R25-2 (SSR-) or Q20-1 (SSR+) - Other terminals and body ground | Always | 10 kΩ or higher |
| Q20-2 (SSR-) or Y2-3 (SSR+) - Other terminals and body ground | Always | 10 kΩ or higher |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G218-7 (GPBS) - R25-1 (SSR+) | Always | Below 1 Ω |
| R25-2 (SSR-) - Q20-1 (SSR+) | Always | Below 1 Ω |
| Q20-2 (SSR-) - X8-2 (SSR+) | Always | Below 1 Ω |
| X8-1 (E) - Body ground | Always | Below 1 Ω |
| G218-7 (GPBS) or R25-1 (SSR+) - Other terminals and body ground | Always | 10 kΩ or higher |
| R25-2 (SSR-) or Q20-1 (SSR+) - Other terminals and body ground | Always | 10 kΩ or higher |
| Q20-2 (SSR-) or X8-2 (SSR+) - Other terminals and body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK (for 3 Door) |
| OK (for 5 Door) |
| NG |
OK (for 3 Door)
OK (for 5 Door)
NG
Disconnect the quarter window assembly LH (glass breakage sensor) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| R25-1 (SSR+) - R25-2 (SSR-) | Always | Below 3.5 Ω |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the quarter window assembly RH (glass breakage sensor) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| Q20-1 (SSR+) - Q20-2 (SSR-) | Always | Below 3.5 Ω |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the Y2*1 or X8*2 back door glass (glass breakage sensor) connector.
*1: w/ Glass Hatch Opener System
*2: w/o Glass Hatch Opener System
| *A | w/ Glass Hatch Opener System |
| *B | w/o Glass Hatch Opener System |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| Y2-3 (SSR+) - Y2-1 (E) | Always | Below 70 Ω |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| X8-2 (SSR+) - X8-1 (E) | Always | Below 70 Ω |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
w/ Glass Hatch Opener System:
Click hereVehicle Exterior>WINDOW / GLASS>BACK DOOR GLASS(for Glass Hatch Type)>REMOVAL
w/o Glass Hatch Opener System:
Click hereVehicle Exterior>WINDOW / GLASS>BACK DOOR GLASS(w/ Back Door Tire Carrier)>REMOVAL