1. PRECAUTION
Be sure to read Precaution thoroughly before servicing.
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION
After the ignition switch is turned off, there may be a waiting time before disconnecting the negative (-) battery terminal.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
67910
3.REMOVE DOOR SCUFF PLATE ASSEMBLY RH (for 4 Sensor Type)
Use the same procedure described for the LH side.
Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING (for 5 Door)>REMOVAL
62111C
4.REMOVE COWL SIDE TRIM BOARD RH (for 4 Sensor Type)
Use the same procedure described for the LH side.
Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING (for 5 Door)>REMOVAL
55317A
5.REMOVE INSTRUMENT SIDE PANEL RH (for 4 Sensor Type)
Use the same procedure described for the LH side.
Click hereVehicle Interior>INTERIOR PANELS / TRIM>INSTRUMENT PANEL SAFETY PAD>REMOVAL
55476C
6.REMOVE INSTRUMENT PANEL FINISH PLATE GARNISH (for 4 Sensor Type)
55480D
7.REMOVE LOWER INSTRUMENT PANEL FINISH PANEL ASSEMBLY (for 4 Sensor Type)
55606
8.REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (for 4 Sensor Type)
55045
9.REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY (for 4 Sensor Type)
73900
10.REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY (for 4 Sensor Type)
82730A
11.REMOVE DRIVER SIDE JUNCTION BLOCK ASSEMBLY (for 4 Sensor Type)
except 5L-E:
Click herePower Source / Network>POWER DISTRIBUTION>MAIN BODY ECU>REMOVAL
for 5L-E:
Click herePower Source / Network>POWER DISTRIBUTION>MAIN BODY ECU>REMOVAL
89340A
12.REMOVE CLEARANCE WARNING ECU ASSEMBLY (for 4 Sensor Type)
Disconnect the connector.
Remove the bolt and clearance warning ECU assembly.
67920
13.REMOVE DOOR SCUFF PLATE ASSEMBLY LH (for 8 Sensor Type)
62112
14.REMOVE COWL SIDE TRIM BOARD LH (for 8 Sensor Type)
55318C
15.REMOVE INSTRUMENT SIDE PANEL LH (for 8 Sensor Type)
55461A
16.REMOVE INSTRUMENT PANEL ORNAMENT (for 8 Sensor Type)
55607
17.REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (for 8 Sensor Type)
55550
18.REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY (for 8 Sensor Type)
89340A
19.REMOVE CLEARANCE WARNING ECU ASSEMBLY (for 8 Sensor Type)
Disconnect the connector.
Remove the 2 nuts and clearance warning ECU assembly.