Use the same procedure for LHD and RHD vehicles.
The procedure listed below is for LHD vehicles.
A bolt without a torque specification is shown in the standard bolt chart.
Click hereGeneral>SPECIFICATIONS>STANDARD BOLT>SPECIFIED TORQUE FOR STANDARD BOLTS
89111
1.INSTALL NETWORK GATEWAY ECU
Attach the 2 claws to install the network gateway ECU.
82878
2.INSTALL ECU INTEGRATION BOX LH (for RHD)
Temporary set the ECU integration box LH to instrument panel reinforcement assembly.
Install the ECU integration box LH with the 2 nuts and bolt.
Attach the 2 clamps.
Connect the 8 connectors.
82877
3.INSTALL ECU INTEGRATION BOX RH (for LHD)
Temporary set the ECU integration box RH to instrument panel reinforcement assembly.
Install the ECU integration box RH with the 2 nuts and bolt.
Attach the 2 clamps.
Connect the 8 connectors.
86740
4.INSTALL TELEPHONE TRANSCEIVER ASSEMBLY (for LHD, w/ Telematics Transceiver, w/o Double Door Lock)
86740
5.INSTALL TELEPHONE TRANSCEIVER ASSEMBLY WITH DOUBLE LOCK DOOR CONTROL RELAY ASSEMBLY (for LHD, w/ Telematics Transceiver, w/ Double Door Lock)
Connect the 4 connectors.
Install the telephone transceiver assembly with double lock door control relay assembly with the bolt and nut.
85940
6.INSTALL WINDSHIELD WIPER RELAY ASSEMBLY (for LHD, Auto Wiper)
87201B
7.INSTALL NO. 2 AIR DUCT SUB-ASSEMBLY
55550
8.INSTALL GLOVE COMPARTMENT DOOR ASSEMBLY
55461A
9.INSTALL INSTRUMENT PANEL ORNAMENT
55317A
10.INSTALL INSTRUMENT SIDE PANEL RH
62311B
11.INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP RH
Install the front door opening trim weatherstrip RH.
55607
12.INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
62111C
13.INSTALL COWL SIDE TRIM BOARD RH
Use the same procedure for the RH side and LH side.
Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING (for 5 Door)>INSTALLATION
67910
14.INSTALL DOOR SCUFF PLATE ASSEMBLY RH
Use the same procedure for the RH side and LH side.
Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING (for 5 Door)>INSTALLATION
15.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
16. INITIALIZATION AFTER RECONNECTING AUXILIARY BATTERY TERMINAL
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>WORK PROCEDURE
When disconnecting and reconnecting the auxiliary battery, there is an automatic learning function that completes learning when the respective system is used.
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>AUTOMATIC LEARNING CHART