Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
89834
1.INSTALL REAR AIRBAG SENSOR LH
Check that the ignition switch is off.
Check that the cable is disconnected from the negative (-) battery terminal.
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
Install the rear airbag sensor with the nut.
If the rear airbag sensor has been dropped, or there are any cracks, dents or other defects in the case, bracket or connector, replace it with a new one.
When installing the rear airbag sensor, be careful that the SRS wiring does not interfere with other parts and that it is not pinched between other parts.
Check that the rear airbag sensor is not loose.
Connect the connector.
64740C
2.INSTALL DECK TRIM SIDE PANEL ASSEMBLY LH
74603C
3.INSTALL ASSIST GRIP SUB-ASSEMBLY (w/ Rear No. 2 Seat)
74617A
4.INSTALL ASSIST GRIP PLUG (w/ Rear No. 2 Seat)
64712F
5.INSTALL FRONT DECK SIDE TRIM COVER
64937A
6.INSTALL NO. 1 TONNEAU COVER HOLDER CAP
64725D
7.INSTALL NO. 1 LUGGAGE COMPARTMENT TRIM HOOK
73233A
8.INSTALL REAR NO. 1 SEAT OUTER LAP BELT ANCHOR COVER
58570C
9.INSTALL REAR FLOOR CARPET ASSEMBLY (w/o Rear No. 2 Seat)
57412C
10.INSTALL FLOOR SIDE RAIL LH (w/ Deck Rail)
57411D
11.INSTALL FLOOR SIDE RAIL RH (w/ Deck Rail)
58574A
12.INSTALL REAR FLOOR MAT REAR SUPPORT PLATE (w/o Rear No. 2 Seat)
58401A
13.INSTALL NO. 1 DECK BOARD SUB-ASSEMBLY (w/o Rear No. 2 Seat)
64717A
14.INSTALL FRONT LUGGAGE COMPARTMENT TRIM COVER (w/o Rear No. 2 Seat)
64910M
15.INSTALL TONNEAU COVER ASSEMBLY (w/ Tonneau Cover)
62332C
16.INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP LH
67918D
17.INSTALL REAR DOOR SCUFF PLATE LH
67934
18.INSTALL QUARTER SCUFF PLATE LH (w/ Rear No. 2 Seat)
58371F
19.INSTALL REAR NO. 1 FLOOR STEP COVER (w/ Rear No. 2 Seat)
20.INSTALL REAR NO. 2 SEAT ASSEMBLY (w/ Rear No. 2 Seat)
for Manual Seat Type LH Side:
Install the rear No. 2 seat assembly (See page Vehicle Interior>SEAT>REAR NO. 2 SEAT ASSEMBLY (for Manual Seat Type LH Side)>INSTALLATION).
for Power Seat Type LH Side:
Install the rear No. 2 seat assembly (See page Vehicle Interior>SEAT>REAR NO. 2 SEAT ASSEMBLY (for Power Seat Type LH Side)>INSTALLATION).
for Face to Face Seat Type:
Install the rear No. 2 seat assembly (See page Vehicle Interior>SEAT>REAR NO. 2 SEAT ASSEMBLY(for Face to Face Seat Type)>INSTALLATION).
21.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
22. INITIALIZATION AFTER RECONNECTING BATTERY TERMINAL
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>WORK PROCEDURE
When disconnecting and reconnecting the battery, there is an automatic learning function that completes learning when the respective system is used.
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>AUTOMATIC LEARNING CHART
23.CHECK SRS WARNING LIGHT
Check the SRS warning light (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>DIAGNOSIS SYSTEM).