Home › Engine / Hybrid System › 1GD-FTV (COOLING) › RADIATOR › from 2020.08
RM27T0E _51 Engine / Hybrid System _053685 1GD-FTV COOLING _0260680 RADIATOR A

1GD-FTV COOLING  RADIATOR  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during radiator assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Disconnect cable from negative (-) battery terminal Correction of steering angle neutral point Multi-terrain monitor system (Click here)

HINT:

When the cable is disconnected/reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.

Learning completes when vehicle is driven

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Lane departure alert system Drive the vehicle straight ahead at 40 km/h (25 mph) or more for 10 seconds or more. (Click here)
Pre-collision system
Lighting system (EXT) (for LED Headlight)
Stop and start system Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes) (Click here)
Vehicle stability control system (for Hydraulic brake booster) Drive the vehicle straight ahead at 40 km/h (25 mph) or more for at least 10 seconds. (Click here)


PROCEDURE

Hide 1. PRECAUTION (for Cold Area Specification Vehicles)

NOTICE:

After turning the engine switch off, waiting time may be required before disconnecting the cable from the battery terminal.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL (for Cold Area Specification Vehicles)

Hide 53292A 3.REMOVE UPPER RADIATOR SUPPORT SEAL

a.

Remove the 13 clips and upper radiator support seal.


Hide 51405A 4.REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY

Hide 82123 7.REMOVE NO. 3 ENGINE WIRE (for Cold Area Specification Vehicles)

a.
A354816

Disconnect 2 cables from 2 positive battery terminals.


b.

Detach the 3 wire harness clamps to disconnect the No. 3 engine wire from the fan shroud.


Hide 16571C 8.REMOVE NO. 1 RADIATOR HOSE

a.
A351914

Slide the 2 hose clamps and remove the No. 1 radiator hose.


Hide 16572D 9.REMOVE NO. 2 RADIATOR HOSE

a.
A351917

Slide the 2 hose clamps and remove the No. 2 radiator hose.


Hide 17342F 10.REMOVE NO. 2 INTERCOOLER AIR HOSE (w/o Urea SCR System)

Hide 17341K 11.REMOVE INTERCOOLER AIR HOSE (w/o Urea SCR System)

a.
A469310C01
1.042,2.323 1.25,2.323 false 2.208,2.313 2.417,2.313 false 1.271,2.24 1.583,2.396 0.313,0.156 10 false *a 2.052,2.219 2.365,2.375 0.313,0.156 10 false *a
*a Retainer


Release the retainers and remove the intercooler air hose as shown in the illustration.


Hide 16552B 12.REMOVE NO. 2 SUB-RADIATOR HOSE (w/ Urea SCR System)

a.
A424400

Slide the 2 hose clamps and remove the No. 2 sub-radiator hose.


Hide 16551B 13.REMOVE NO. 1 SUB-RADIATOR HOSE (w/ Urea SCR System)

a.
A424424

Detach the clamp to disconnect the No. 1 sub-radiator hose from the fan shroud.


b.

Slide the 2 hose clamps and remove the No. 1 sub-radiator hose.


Hide 161B0 14.REMOVE ELECTRIC WATER PUMP ASSEMBLY (w/ Urea SCR System)

a.
A424426

Detach the connector and 4 wire harness clamps to disconnect the wire harness.


b.
A421626

Remove the 2 bolts and electric water pump assembly.


Hide 16553B 15.REMOVE NO. 3 SUB-RADIATOR HOSE (w/ Urea SCR System)

a.
A424401

Detach the clamp to disconnect the No. 3 sub-radiator hose from the radiator reservoir assembly.


b.

Slide the 2 hose clamps and remove the No. 3 sub-radiator hose.


Hide 16554B 16.REMOVE NO. 4 SUB-RADIATOR HOSE (w/ Urea SCR System)

a.
A424402

Detach the clamp to disconnect the No. 4 sub-radiator hose from the fan shroud.


b.

Slide the 2 hose clamps and remove the No. 4 sub-radiator hose.


Hide 16640 17.REMOVE INTERCOOLER RESERVOIR ASSEMBLY (w/ Urea SCR System)

a.
A424425

Remove the 3 bolts and intercooler reservoir assembly.


Hide 16470 18.REMOVE RADIATOR RESERVOIR ASSEMBLY

a.
A351918

Detach the 2 clamps to disconnect the No. 2 water by-pass hose from the fan shroud.


b.

Slide the hose clamp and disconnect the No. 2 water by-pass hose from the water inlet.


c.
A351919

Slide the hose clamp and disconnect the No. 1 water by-pass hose from the radiator assembly.


d.

Detach the 2 clamps to disconnect the No. 1 water by-pass hose from the fan shroud.


e.

Remove the 3 bolts and radiator reservoir assembly.


Hide 19.DISCONNECT OIL COOLER HOSE (for Automatic Transmission)

a.
A351920

Remove the bolt and detach the 2 clamps to disconnect the oil cooler hose from the fan shroud.


b.

Slide the 2 hose clamps and disconnect the oil cooler hose from radiator assembly.


Hide 88359 20.REMOVE VISCOUS HEATER V BELT (w/ Viscous Heater)

Hide 16711 21.REMOVE FAN SHROUD

a.
A341285

Loosen the 4 nuts holding the fan with fluid coupling assembly.


b.

Remove the fan and generator V belt.

Click hereEngine / Hybrid System>1GD-FTV (ENGINE MECHANICAL)>DRIVE BELT>REMOVAL


c.
A351921

w/o Urea SCR System:

Remove the 2 bolts holding the fan shroud.


d.
A424395

w/ Urea SCR System:

Remove the 4 bolts holding the fan shroud.


e.

Slide the fan shroud in upper side to detach the guide and remove the fan shroud together with the fan with fluid coupling assembly.

NOTICE:

Be careful not to damage the radiator core.



f.

Remove the fan pulley.


Hide 52129B 22.REMOVE FRONT BUMPER LOWER COVER

Hide 52119A 23.REMOVE FRONT BUMPER COVER

Hide 52521 24.REMOVE FRONT BUMPER CENTER UPPER RETAINER

Hide 53293C 25.REMOVE RADIATOR SIDE DEFLECTOR RH

a.
A409569

Detach the 3 claws and remove the clip and radiator side deflector RH.


Hide 53294C 26.REMOVE RADIATOR SIDE DEFLECTOR LH

a.
A409570

Detach the 3 claws and remove the clip and radiator side deflector LH.


Hide 16400 27.REMOVE RADIATOR ASSEMBLY

a.
A351922

Remove the 4 bolts and radiator assembly.


Hide 16563 28.REMOVE NO. 3 RADIATOR TO SUPPORT SEAL

a.
A244952

Remove the No. 3 radiator to support seal from the No. 1 radiator air guide.


Hide 16593 29.REMOVE NO. 1 RADIATOR AIR GUIDE

a.
A245988

Remove the 2 bolts and No. 1 radiator air guide.


Hide 16550 31.REMOVE INTERCOOLER COOLING RADIATOR ASSEMBLY (w/ Urea SCR System)

Hide 17940D 32.REMOVE INTERCOOLER ASSEMBLY (w/o Urea SCR System)

Hide 12209F 33.REMOVE OIL RETURN PIPE SUB-ASSEMBLY (w/o Urea SCR System)

a.

Detach the 2 clamps to remove the oil return pipe sub-assembly from the radiator assembly.