Power is supplied to the radio receiver assembly and steering pad switch assembly illumination when the headlight dimmer switch is in the tail or head position.
The vehicle is equipped with a Supplemental Restraint System (SRS) which includes components such as airbags. Before servicing (including removal or installation of parts), be sure to read the precaution for Supplemental Restraint System (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION).
Inspect the fuse for circuits related to this system before performing the following inspection procedure.
When replacing the radio receiver assembly, it is necessary to perform the vehicle contract setting for Connected Services (w/ Connected Services Function).
Check if the illumination for the radio receiver assembly, steering pad switch assembly or others (hazard switch etc.) comes on when the headlight dimmer switch is turned to the head or tail position.
| Result | Proceed to |
|---|---|
| Illumination comes on for all components except steering pad switch assembly. | A |
| Illumination comes on for all components except radio receiver assembly. | B |
| No illumination comes on (radio receiver assembly, steering pad switch, hazard switch, heater control switch, etc.). | C |
A
B
C
except 5L-E:
(See pageVehicle Interior>LIGHTING (INT)>LIGHTING SYSTEM (except 5L-E)>HOW TO PROCEED WITH TROUBLESHOOTING)
for 5L-E:
Click hereVehicle Interior>LIGHTING (INT)>LIGHTING SYSTEM (for 5L-E)>HOW TO PROCEED WITH TROUBLESHOOTING
Disconnect the spiral cable sub-assembly connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| G208-13 (IL+2) - Body ground | Light control switch in the tail or head position | 11 to 14 V |
| *a | Front view of wire harness connector
(to Spiral Cable Sub-assembly) |
OK
NG
Remove the steering pad switch assembly (See page Steering>STEERING COLUMN>STEERING WHEEL>REMOVAL).
Inspect the steering pad switch assembly (See page Steering>STEERING COLUMN>STEERING WHEEL>INSPECTION).
OK
NG
Remove the spiral cable sub-assembly (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>SPIRAL CABLE>REMOVAL).
Inspect the spiral cable sub-assembly (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>SPIRAL CABLE>INSPECTION).
OK
NG
Disconnect the H46 and H47 radio receiver assembly connectors.
Disconnect the G208 spiral cable sub-assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| H47-23 (SWG) - G208-3 (EAU) | Always | Below 1 Ω |
| H46-7 (GND1) - Body ground | Always | Below 1 Ω |
| H47-23 (SWG) - Body ground | Always | 10 kΩ or higher |
OK
NG
Disconnect the radio receiver assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| H46-7 (GND1) - Body ground | Always | Below 1 Ω |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| H46-10 (ILL+) - Body ground | Light control switch in the tail or head position | 11 to 14 V |
| *a | Front view of wire harness connector
(to Radio Receiver Assembly) |
OK
NG