Home › Suspension › SUSPENSION CONTROL › KINETIC DYNAMIC SUSPENSION SYSTEM › from 2021.06
RM27T0E _53 Suspension _053706 SUSPENSION CONTROL _0260886 KINETIC DYNAMIC SUSPENSION SYSTEM S

SUSPENSION CONTROL  KINETIC DYNAMIC SUSPENSION SYSTEM  DIAGNOSTIC TROUBLE CODE CHART  


NOTICE:

Turn the ignition switch off before removing parts.


HINT:
·

If no abnormality is found when inspecting parts, inspect the skid control ECU and ground points for poor contact.

·

If a trouble code is output during the DTC check, check the circuit indicated by the DTC. For details of each code, refer to the "See page" for the respective "DTC Code" in the DTC chart.

·

When 2 or more DTCs are output, perform circuit inspections one by one until the problem is identified.

·

Inspect the fuse and relay before investigating the trouble areas as shown in the table below.



Kinetic Dynamic Suspension System
DTC Code Detection Item See page
C1812 Pressure Sensor Circuit Malfunction (Click here)
C1831 Accumulator Solenoid (Upside) Malfunction (Click here)
C1832 Accumulator Solenoid (Downside) Malfunction (Click here)
C1851 Low Pressure Malfunction in KDSS System (Click here)
C1853 High Pressure Malfunction in KDSS System (Click here)
C1879 Zero Point Calibration Acceleration Sensor Adjustment Undone (Click here)
C1881 KDSS ECU Malfunction (Click here)
C1882 Power Supply Voltage Malfunction (Click here)
C1883 Speed Sensor Circuit Malfunction (Click here)
C1884 Steering Angle Sensor Circuit Malfunction (Click here)
C1887 Acceleration Sensor Circuit Malfunction (Click here)
U0100 Lost Communication with ECM/PCM "A" (Click here)
U0122 Lost Communication with Vehicle Dynamics Control Module (Click here)
U0124 Lost Communication with Lateral Acceleration Sensor Module (Click here)
U0126 Lost Communication with Steering Angle Sensor Module (Click here)