The stabilizer control ECU receives forward, backward and lateral acceleration information from the yaw rate and acceleration sensor via CAN communication.
| DTC Code | DTC Detection Condition | Trouble Area |
|---|---|---|
| C1887 | The stabilizer control ECU receives an error signal from the yaw rate and acceleration sensor for 1 second. | ·
Yaw rate and acceleration sensor ·
Yaw rate and acceleration sensor circuit ·
Stabilizer control ECU |
If DTC U0124 and C1887 are output at the same time, perform the inspection necessary for the CAN communication system first (See page Suspension>SUSPENSION CONTROL>KINETIC DYNAMIC SUSPENSION SYSTEM>U0100).
Check for yaw rate and acceleration sensor malfunction DTCs (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM (for Hydraulic Brake Booster)>DTC CHECK / CLEAR).
| Result | Proceed to |
|---|---|
| DTC is not output | A |
| DTC is output | B |
A
B
Clear the DTCs (See page Suspension>SUSPENSION CONTROL>KINETIC DYNAMIC SUSPENSION SYSTEM>DTC CHECK / CLEAR).
Perform a road test.
Check for DTCs (See page Suspension>SUSPENSION CONTROL>KINETIC DYNAMIC SUSPENSION SYSTEM>DTC CHECK / CLEAR).
| Result | Proceed to |
|---|---|
| DTC is not output | A |
| DTC is output | B |
A
(See pageGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING)
B