Cruise Main Indicator Light Circuit
Circuit diagnosis · Vehicles built Sep 2011 – Dec 2011
Versions by build date: Sep 2011 – Dec 2011 from Jan 2012
DESCRIPTION
- The ECM detects a cruise control switch signal and sends it to the combination meter via the CAN communication line. Then the CRUISE main indicator light comes on.
- The CRUISE main indicator light circuit uses the CAN for communication. If there is a malfunction in this circuit, check for DTCs in the CAN communication system before troubleshooting this circuit.
WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. PERFORM ACTIVE TEST USING INTELLIGENT TESTER (CRUISE MAIN INDICATOR LIGHT) |
Using the intelligent tester, perform the Active Test.
Combination Meter Tester Display
Test Part
Control Range
Diagnostic Note
Indicat. Lamp Cruise
CRUISE main indicator light operation
OFF or ON
-
- OK:
- Indicator light comes on/goes off.
Result Result
Proceed to
OK
A
NG
(w/ Multi-information Display)
B
NG
(w/o Multi-information Display)
C
|
|
||||
|
|
||||
| A | |
| 2. READ VALUE USING INTELLIGENT TESTER (CRUISE MAIN INDICATOR LIGHT) |
Using the intelligent tester, read the Data List.
Cruise Control Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
CCS Indicator M-CPU
CRUISE main indicator light (Main CPU) / ON or OFF
ON: CRUISE main indicator light is on
OFF: CRUISE main indicator light is off
-
- OK:
- The intelligent tester display changes according to condition of CRUISE main indicator light.
Result Result
Proceed to
OK
A
NG
(for 3UR-FE)
B
NG
(for 2UZ-FE)
C
NG
(for 1GR-FE)
D
NG
(for 1VD-FTV)
E
|
|
||||
|
|
||||
|
|
||||
|
|
||||
| A | ||
| ||
