2011-2013 Land Cruiser · Service Manual Vehicle Interior

Odo/Trip Switch Malfunction

Circuit diagnosis · Vehicles built from Sep 2011

DESCRIPTION

w/ Multi-information Display:
The ODO/TRIP display of the meter changes each time the ODO/TRIP switch on the light control rheostat is pressed.

HINT:
For more information about changing between displays, refer to the owner's manual.


WIRING DIAGRAM

E156917E01

INSPECTION PROCEDURE


1. READ VALUE USING INTELLIGENT TESTER (LIGHT CONTROL RHEOSTAT)
  1. Operate the intelligent tester according to the display and select Data List.

    Combination Meter 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    ODO/TRIP Change SW
    Trip switch (ODO/TRIP switch) condition/ON or OFF
    ON: Trip switch pushed
    OFF: Trip switch not pushed
    -

    OK:
    Switch condition (ON/OFF) can be switched by actual operation.



NG
Go to step 2
OK

REPLACE COMBINATION METER ASSEMBLY (Click here)

2. INSPECT LIGHT CONTROL RHEOSTAT (TRIP SWITCH)

  1. E157799E01
    Remove the light control rheostat (Click here).

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    4 (A/B) - 1 (E)
    TRIP switch ON (Pushed)
    Below 200 Ω
    TRIP switch OFF (Not pushed)
    1 MΩ or higher



NG
REPLACE LIGHT CONTROL RHEOSTAT (Click here)
OK


3. CHECK HARNESS AND CONNECTOR (COMBINATION METER - LIGHT CONTROL RHEOSTAT AND BODY GROUND)

  1. E156954E03
    Disconnect the E8 ECU connector.

  1. Disconnect the E9 switch connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    E8-4 (RSET) - E9-4 (A/B)
    Always
    Below 1 Ω
    E8-23 (E2) - E9-1 (E)
    E8-23 (E2) - Body ground
    E8-4 (RSET) or E9-4 (A/B) - Body ground
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE COMBINATION METER ASSEMBLY (Click here)


← Engine Coolant Temperature Gauge Malfunction (from Jan 2012)Operating Light Control Rheostat does not Change Light Brightness (from Sep 2011) →