If the manual up/down function does not operate, there may be a malfunction in the power window regulator switch assembly, front power window regulator motor assembly LH*1 or RH*2, multiplex network master switch assembly or harness or connector.
*1: for LHD
*2: for RHD
WIRING DIAGRAM
INSPECTION PROCEDURE
1. INSPECT POWER WINDOW REGULATOR SWITCH ASSEMBLY
Remove the power window regulator switch assembly (Click here).
Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection
Switch Condition
Specified Condition
4 (U) - 3 (B)
UP
Below 1 Ω
2 (SD) - 1 (D)
5 (SU) - 4 (U)
OFF
Below 1 Ω
2 (SD) - 1 (D)
5 (SU) - 4 (U)
DOWN
Below 1 Ω
3 (B) - 1 (D)
NG
REPLACE POWER WINDOW REGULATOR SWITCH ASSEMBLY (Click here)
OK
2. INSPECT FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY
Remove the front passenger side power window regulator motor assembly (Click here).
Apply battery voltage to the motor connector according to the table below.
Text in Illustration
*A
for LHD
*B
for RHD
*1
Motor Gear
-
-
*a
Counterclockwise
*b
Clockwise
OK:
Measurement Condition
Specified Condition
Battery positive (+) → 1 Battery negative (-) → 2
Motor gear rotates clockwise
Battery positive (+) → 2 Battery negative (-) → 1
Motor gear rotates counterclockwise
Result
Result
Proceed to
OK
A
NG (for LHD)
B
NG (for RHD)
C
B
REPLACE FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY RH (Click here)
C
REPLACE FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY LH (Click here)