Rear Power Window LH does not Operate with Rear Power Window Switch LH
Circuit diagnosis · Vehicles built Sep 2011 – Dec 2011
Versions by build date: Sep 2011 – Dec 2011from Jan 2012
DESCRIPTION
If the manual up/down function does not operate, there may be a malfunction in the rear power window regulator switch, power window rear regulator motor LH, multiplex network master switch assembly, harness or connector.
WIRING DIAGRAM
INSPECTION PROCEDURE
1. INSPECT REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY LH
Remove the rear power window regulator switch assembly LH (Click here).
Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection
Switch Condition
Specified Condition
4 (U) - 3 (B)
UP
Below 1 Ω
2 (SD) - 1 (D)
5 (SU) - 4 (U)
OFF
Below 1 Ω
2 (SD) - 1 (D)
5 (SU) - 4 (U)
DOWN
Below 1 Ω
3 (B) - 1 (D)
NG
REPLACE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY LH (Click here)
OK
2. INSPECT REAR POWER WINDOW REGULATOR MOTOR ASSEMBLY LH
Remove the rear window regulator motor assembly LH (Click here).
Apply battery voltage to the motor connector according to the table below.
Text in Illustration
*1
Motor Gear
*a
Counterclockwise
*b
Clockwise
OK:
Measurement Condition
Specified Condition
Battery positive (+) → 1 Battery negative (-) → 2
Motor gear rotates clockwise
Battery positive (+) → 2 Battery negative (-) → 1
Motor gear rotates counterclockwise
NG
REPLACE REAR POWER WINDOW REGULATOR MOTOR ASSEMBLY LH (Click here)
OK
3. CHECK HARNESS AND CONNECTOR (REAR POWER WINDOW REGULATOR SWITCH LH - BATTERY)
Disconnect the J23 rear power window regulator switch assembly LH connector.
Measure the voltage according to the value(s) in the table below.
Standard Voltage:
Tester Connection
Switch Condition
Specified Condition
J23-3 (B) - Body ground
Ignition switch ON
11 to 14 V
Text in Illustration
*a
Front view of wire harness connector (to Rear Power Window Regulator Switch Assembly LH)
NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK
4. CHECK HARNESS AND CONNECTOR (REAR POWER WINDOW REGULATOR SWITCH LH - REAR POWER WINDOW REGULATOR MOTOR LH)
Disconnect the J23 rear power window regulator switch assembly LH connector.
Disconnect the J22 rear power window regulator motor assembly LH connector.
Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection
Condition
Specified Condition
J23-4 (U) - J22-1
Always
Below 1 Ω
J23-1 (D) - J22-2
Always
Below 1 Ω
J23-4 (U) or J22-1 - Body ground
Always
10 KΩ or higher
J23-1 (D) or J22-2 - Body ground
Always
10 KΩ or higher
NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK
5. CHECK HARNESS AND CONNECTOR (REAR POWER WINDOW REGULATOR SWITCH LH - MULTIPLEX NETWORK MASTER SWITCH)
Disconnect the J23 rear power window regulator switch assembly LH connector.
Disconnect the I31*1 or I26*2 multiplex network master switch assembly connector.
*1: for LHD
*2: for RHD
Measure the resistance according to the value(s) in the table below.