2011-2013 Land Cruiser · Service Manual Steering

C1591/51 Actuator Neutral Position Calibration Undone

Diagnostic trouble codes · Vehicles built from Jan 2012

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012

DESCRIPTION

If the steering control ECU or steering actuator is replaced, or if the tie-rod ends are adjusted, VGRS system calibration is required. If the steering control ECU detects that steering angle adjustment is incomplete, it will store DTC C1591/51.
DTC Code
DTC Detection Condition
Procedure
C1591/51
The steering control ECU detects that steering angle adjustment is incomplete.
There is no malfunction if this DTC is not output again after performing VGRS system calibration.

INSPECTION PROCEDURE


1. CHECK DTC
  1. Check for DTCs (Click here).

    OK:
    DTC C1591/51 only is output.



NG
REPAIR CIRCUIT INDICATED BY DTC OUTPUT
OK


2. PERFORM VGRS SYSTEM CALIBRATION
  1. Perform VGRS system calibration (Click here).


NEXT


3. CHECK DTC
  1. Check for DTCs (Click here).

    Result 
    Result
    Proceed to
    DTC is not output.
    A
    DTC C1592/52 is output.
    B
    DTC C1593/53 is output.
    C



B
GO TO DTC C1592/52 (Click here)

C
GO TO DTC C1593/53 (Click here)
A

USE SIMULATION METHOD TO CHECK (Click here)


← C1591/51 Actuator Neutral Position Calibration Undone (Sep 2011 – Dec 2011)C1592/52 Actuator Neutral Position Calibration Incomplete (Sep 2011 – Dec 2011) →