2011-2013 Land Cruiser · Service Manual Brake

DIAGNOSIS SYSTEM

Troubleshooting · Vehicles built Sep 2011 – Dec 2011

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012


DIAGNOSIS
  1. If the skid control ECU detects a malfunction, the ABS/BRAKE warning lights and VSC OFF*2/SLIP/CRAWL indicator lights and/or "Check VSC System" on the multi-information display*1 will come on to warn the driver.
    The table below indicates which lights will come on when there is a malfunction in a particular function.

    HINT:
    *1: w/ Multi-information Display
    *2: w/o Multi-information Display

Item/Trouble Area
Multi-terrain ABS
BA
EBD
VSC
A-TRC
CRAWL Control
Hill-start Assist Control
ABS Warning Light
○
○
○
-
-
-
-
BRAKE Warning Light
-
-
○
-
-
-
-
VSC OFF Indicator Light
○
○
○
○
○
○
○
SLIP Indicator Light
○
○
○
○
○
○
○
CRAWL Indicator Light
-
-
-
-
-
●
(During CRAWL control operation)
-
○: Light on ●: Light on (Blinking) -: Light off
  1. The DTCs are simultaneously stored in memory. The DTCs can be read by connecting SST between terminals 13 (TC) and 4 (CG) of the DLC3 and observing the blinking of the ABS warning light and the VSC OFF indicator light, or by connecting the intelligent tester.
  2. This system has a signal check function (test mode).

WARNING LIGHT AND INDICATOR LIGHT CHECK
  1. Release the parking brake lever.

    NOTICE:
    When releasing the parking brake, set chocks to hold the vehicle for safety.

    HINT:
    When the parking brake is applied or the level of the brake fluid is low, the BRAKE warning light comes on.

  2. When the ignition switch is turned to ON, check that the ABS and BRAKE warning lights and the VSC OFF, SLIP, and CRAWL indicator lights turn on and then turn off after the engine starts.
    If a light remains on, proceed to troubleshooting for the light circuit below.

    Trouble Area
    See Procedure
    ABS warning light circuit
    Click here
    BRAKE warning light circuit
    Click here
    VSC OFF indicator light circuit
    Click here
    SLIP indicator light circuit
    Click here

← TERMINALS OF ECU (from Jan 2012)DIAGNOSIS SYSTEM (from Jan 2012) →