2011-2013 Land Cruiser · Service Manual Brake

C1249/49 Open in Stop Light Switch Circuit

Diagnostic trouble codes · Vehicles built Sep 2011 – Dec 2011

DESCRIPTION

The stop light switch signal is input to the skid control ECU and the skid control ECU detects the status of brake operation.
The skid control ECU has an open detection circuit.
If an open in the stop light switch input line or GND side stop light circuit is detected when the stop light switch is off, this DTC is stored.
DTC Code
DTC Detection Condition
Trouble Area
C1249/49
The ECU terminal IG1 voltage is 9.5 to 17.0 V, ABS is not operating, and an open in the stop light switch circuit continues for 3 seconds or more.
  1. STP terminal circuit
  2. Stop light LH and RH circuit
  3. Master cylinder solenoid (Skid control ECU)

WIRING DIAGRAM

C247214E01

INSPECTION PROCEDURE

NOTICE:
When replacing the master cylinder solenoid, perform zero point calibration (Click here).


1. CHECK STOP LIGHT OPERATION
  1. Check that the stop light come on when the brake pedal is depressed, and go off when the brake pedal is released.

    OK:
    Condition
    Illumination Condition
    Brake pedal depressed
    On
    Brake pedal released
    Off



NG
GO TO LIGHTING SYSTEM (STOP LIGHT CIRCUIT) (Click here)
OK


2. INSPECT SKID CONTROL ECU (STP TERMINAL)

  1. C173351E11
    Disconnect the A24 skid control ECU connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    A24-7 (STP) - Body ground
    Brake pedal depressed
    8 to 14 V
    Brake pedal released
    Below 1.5 V

    Result 
    Result
    Proceed to
    OK (When troubleshooting in accordance with the Diagnostic Trouble Code Chart)
    A
    OK (When troubleshooting in accordance with the Problem Symptoms Table)
    B
    NG
    C



B
PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)

C
REPAIR OR REPLACE HARNESS OR CONNECTOR
A


3. RECONFIRM DTC
  1. Clear the DTC (Click here).

  1. Check if the same DTC is output (Click here).

    Result 
    Result
    Proceed to
    DTC is not output
    A
    DTC is output
    for LHD
    B
    for RHD
    C



B
REPLACE MASTER CYLINDER SOLENOID (Click here)

C
REPLACE MASTER CYLINDER SOLENOID (Click here)
A

USE SIMULATION METHOD TO CHECK (Click here)


← C1246/46 Master Cylinder Pressure Sensor Malfunction (Sep 2011 – Dec 2011)C1251 Open in Pump Motor Circuit (from Jan 2012) →