PROBLEM SYMPTOMS TABLE
Troubleshooting · Vehicles built Sep 2011 – Dec 2011
Versions by build date: Sep 2011 – Dec 2011 from Jan 2012
If there are no DTCs output but the problem still occurs, check the circuits for each problem symptom in the order given in the table below and proceed to the relevant "See page".
- NOTICE:
- When replacing the master cylinder solenoid, sensor, etc., turn the ignition switch off.
- HINT:
- Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
- Inspect the fuses and relays related to this system before inspecting the suspected areas below.
- Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
| Symptom |
Suspected Area |
See page |
| Multi-terrain ABS, BA and/or EBD does not Operate |
Check for DTCs again and make sure that no DTC is output. |
Click here
|
| IG power source circuit |
Click here
|
|
| Front speed sensor circuit |
Click here
|
|
| Rear speed sensor circuit |
Click here
|
|
| Yaw rate and G sensor circuit |
Click here
|
|
| Check the hydraulic brake booster with intelligent tester. If abnormal, check the hydraulic circuit for leakage. |
Click here
|
|
| If the symptoms still occur even after the above circuits in suspected areas are inspected and proved to be normal, replace the master cylinder solenoid. <LHD> |
Click here
|
|
| If the symptoms still occur even after the above circuits in suspected areas are inspected and proved to be normal, replace the master cylinder solenoid. <RHD> |
Click here
|
|
| Multi-terrain ABS, BA and/or EBD does not Operate Efficiently |
Check for DTCs again and make sure that no DTC is output. |
Click here
|
| Front speed sensor circuit |
Click here
|
|
| Rear speed sensor circuit |
Click here
|
|
| Stop light switch circuit |
Click here
|
|
| Yaw rate and G sensor circuit |
Click here
|
|
| Check the hydraulic brake booster with intelligent tester. If abnormal, check the hydraulic circuit for leakage. |
Click here
|
|
| If the symptoms still occur even after the above circuits in suspected areas are inspected and proved to be normal, replace the master cylinder solenoid. <LHD> |
Click here
|
|
| If the symptoms still occur even after the above circuits in suspected areas are inspected and proved to be normal, replace the master cylinder solenoid. <RHD> |
Click here
|
|
| VSC, A-TRC, CRAWL and/or Hill-start Assist Control does not Operate |
Check for DTCs again and make sure that no DTC is output. |
Click here
|
| IG power source circuit |
Click here
|
|
| Check the hydraulic circuit for leakage |
Click here
|
|
| Front speed sensor circuit |
Click here
|
|
| Rear speed sensor circuit |
Click here
|
|
| Yaw rate and G sensor circuit |
Click here
|
|
| Steering angle sensor circuit |
Click here
|
|
| If the symptoms still occur even after the above circuits in suspected areas are inspected and proved to be normal, replace the master cylinder solenoid. <LHD> |
Click here
|
|
| If the symptoms still occur even after the above circuits in suspected areas are inspected and proved to be normal, replace the master cylinder solenoid. <RHD> |
Click here
|
|
| Sensor and Switch Signal Check cannot be Done |
TS and CG terminal circuit |
Click here
|
| Master cylinder solenoid <LHD> |
Click here
|
|
| Master cylinder solenoid <RHD> |
Click here
|
|
| DTC Check cannot be Done |
Check for DTCs again and make sure that no DTC is output. |
Click here
|
| TC and CG terminal circuit |
Click here
|
|
| If the symptoms still occur even after the above circuits in suspected areas are inspected and proved to be normal, replace the master cylinder solenoid. <LHD> |
Click here
|
|
| If the symptoms still occur even after the above circuits in suspected areas are inspected and proved to be normal, replace the master cylinder solenoid. <RHD> |
Click here
|
|
| ABS Warning Light Abnormal (Remains On) |
ABS warning light circuit |
Click here
|
| Master cylinder solenoid <LHD> |
Click here
|
|
| Master cylinder solenoid <RHD> |
Click here
|
|
| ABS Warning Light Abnormal (Does not Come On) |
ABS warning light circuit |
Click here
|
| Master cylinder solenoid <LHD> |
Click here
|
|
| Master cylinder solenoid <RHD> |
Click here
|
|
| BRAKE Warning Light Abnormal (Remains On) |
BRAKE warning light circuit |
Click here
|
| Brake fluid level warning switch circuit |
Click here
|
|
| Master cylinder solenoid <LHD> |
Click here
|
|
| Master cylinder solenoid <RHD> |
Click here
|
|
| BRAKE Warning Light Abnormal (Does not Come On) |
BRAKE warning light circuit |
Click here
|
| Master cylinder solenoid <LHD> |
Click here
|
|
| Master cylinder solenoid <RHD> |
Click here
|
|
| VSC OFF Indicator Light Abnormal (Remains On) |
Transfer indicator (L4) switch circuit |
Click here
|
| VSC OFF indicator light circuit |
Click here
|
|
| Center differential lock circuit |
Click here
|
|
| Master cylinder solenoid <LHD> |
Click here
|
|
| Master cylinder solenoid <RHD> |
Click here
|
|
| VSC OFF Indicator Light Abnormal (Does not Come On) |
Transfer indicator (L4) switch circuit |
Click here
|
| VSC OFF indicator light circuit |
Click here
|
|
| Master cylinder solenoid <LHD> |
Click here
|
|
| Master cylinder solenoid <RHD> |
Click here
|
|
| CRAWL Indicator Light Abnormal (Remains On) |
CRAWL indicator light circuit |
Click here
|
| Master cylinder solenoid <LHD> |
Click here
|
|
| Master cylinder solenoid <RHD> |
Click here
|
|
| CRAWL Indicator Light Abnormal (Does not Come On) |
CRAWL indicator light circuit |
Click here
|
| Master cylinder solenoid <LHD> |
Click here
|
|
| Master cylinder solenoid <RHD> |
Click here
|
|
| SLIP Indicator Light Abnormal (Remains On) |
SLIP indicator light circuit |
Click here
|
| Master cylinder solenoid <LHD> |
Click here
|
|
| Master cylinder solenoid <RHD> |
Click here
|
|
| SLIP Indicator Light Abnormal (Does not Come On) |
SLIP indicator light circuit |
Click here
|
| Master cylinder solenoid <LHD> |
Click here
|
|
| Master cylinder solenoid <RHD> |
Click here
|
|
| Skid Control Buzzer Abnormal |
Skid control buzzer circuit |
Click here
|
| Master cylinder solenoid <LHD> |
Click here
|
|
| Master cylinder solenoid <RHD> |
Click here
|