2011-2013 Land Cruiser · Service Manual Vehicle Exterior

Back Door Lock Motor Circuit

Circuit diagnosis · Vehicles built from Jan 2012

DESCRIPTION

The back door lock motor is built into the back door lock assembly. The power back door unit assembly (power back door ECU) controls the back door lock motor to open/close the back door. This power back door unit assembly (power back door ECU) applies current to terminals 2 and 1 to operate the motor to close the door. It reverses the direction of the current to operate the motor to open the door.

WIRING DIAGRAM

B312267E01

INSPECTION PROCEDURE


1. INSPECT BACK DOOR LOCK ASSEMBLY (CLOSER MOTOR OPERATION)
  1. Remove the back door lock assembly (Click here).

  1. Inspect the back door lock assembly (Click here).



NG
REPLACE BACK DOOR LOCK ASSEMBLY (Click here)
OK


2. CHECK HARNESS AND CONNECTOR (BACK DOOR LOCK ASSEMBLY - POWER BACK DOOR UNIT ASSEMBLY [POWER BACK DOOR ECU])
  1. Disconnect the S22 back door lock assembly connector.

  1. Disconnect the L52 power back door unit assembly (power back door ECU) connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    S22-1 (M+) - L52-2 (DC+)
    Always
    Below 1 Ω
    S22-2 (M-) - L52-1 (DC-)
    Always
    Below 1 Ω
    S22-1 (M+) - Body ground
    Always
    10 kΩ or higher
    S22-2 (M-) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)


← B2251 Back Door Closer Switch Malfunction (from Jan 2012)Power Back Door Opener / Closer Switch Circuit (from Jan 2012) →