2011-2013 Land Cruiser · Service Manual Vehicle Exterior

Rear Window Defogger System does not Operate

Circuit diagnosis · Vehicles built Sep 2011 – Dec 2011

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012

DESCRIPTION

When the rear window defogger switch is turned on, a rear window defogger activation request signal is sent via the LIN communication line*1 or CAN communication line*2 to the air conditioning amplifier. Then the air conditioning amplifier operates the rear window defogger. When the on signal from the switch is received, the defogger relay (DEFOG) is operated for 15 minutes. Also, if the off signal from the switch is received within 15 minutes, the defogger relay (DEFOG) operation is stopped.

HINT:
*1: w/o Multi-display
*2: w/ Multi-display


WIRING DIAGRAM

B187446E02

INSPECTION PROCEDURE


1. CHECK FOR DTC
  1. Check for DTC.

    Result 
    Result
    Proceed to
    DTC is not output
    A
    LIN DTC is output
    B
    CAN DTC is output (for LHD)
    C
    CAN DTC is output (for RHD)
    D



B
GO TO LIN COMMUNICATION SYSTEM (Click here)

C
GO TO CAN COMMUNICATION SYSTEM (Click here)

D
GO TO CAN COMMUNICATION SYSTEM (Click here)
A


2. PERFORM ACTIVE TEST USING INTELLIGENT TESTER (DEFOGGER RELAY)
  1. Select the Active Test using the intelligent tester to generate a control command, and then check that the rear window defogger operates.

    Air Conditioner 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Defogger Relay (Rear)
    Rear window defogger relay operation
    OFF or ON
    -
    Result 
    Result
    Proceed to
    Rear window defogger operates normally (w/o Multi-display)
    A
    Rear window defogger operates normally (w/ Multi-display)
    B
    Rear window defogger does not operate
    C



B
Go to step 5

C
Go to step 7
A


3. REPLACE AIR CONDITIONING CONTROL ASSEMBLY
  1. Temporarily replace the air conditioning control assembly with a new or normally functioning one (Click here).


NEXT


4. CHECK WINDOW DEFOGGER SYSTEM
  1. Turn the engine switch on (IG).

  1. Check that pressing the defogger switch illuminates the indicator and warms the rear window surface.

  1. Check that after approximately 15 minutes, the indicator light turns off and the rear window defogger deactivates.

    OK:
    Rear window defogger system functioning normally.



NG
REPLACE AIR CONDITIONING AMPLIFIER (Click here)
OK

END (AIR CONDITIONING CONTROL ASSEMBLY IS DEFECTIVE)

5. REPLACE MULTI-DISPLAY
  1. Temporarily replace the multi-display with a new or normally functioning one (Click here).


NEXT


6. CHECK WINDOW DEFOGGER SYSTEM
  1. Turn the engine switch on (IG).

  1. Check that pressing the defogger switch illuminates the indicator and warms the rear window surface.

  1. Check that after approximately 15 minutes, the indicator light turns off and the rear window defogger deactivates.

    OK:
    Rear window defogger system functioning normally.



NG
REPLACE AIR CONDITIONING AMPLIFIER (Click here)
OK

END (MULTI-DISPLAY IS DEFECTIVE)

7. INSPECT FUSE (DEFOG)
  1. Remove the DEFOG fuse from the engine room junction block.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    DEFOG fuse
    Always
    Below 1 Ω



NG
REPLACE FUSE
OK


8. INSPECT DEFOGGER RELAY (DEFOG)
B106753E01
  1. Remove the defogger relay from the engine room junction block.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    3 - 4
    Battery voltage is not applied to terminals 1 and 2
    Below 1 Ω
    3 - 5
    10 kΩ or higher
    3 - 4
    Battery voltage is applied to terminals 1 and 2
    10 kΩ or higher
    3 - 5
    Below 1 Ω

    Result 
    Result
    Proceed to
    OK (w/ Rear air conditioning amplifier)
    A
    OK (w/o Rear air conditioning amplifier)
    B
    NG
    C



B
Go to step 12

C
REPLACE DEFOGGER RELAY
A


9. CHECK HARNESS AND CONNECTOR (DEFOGGER RELAY - BATTERY AND AIR CONDITIONING AMPLIFIER)
B186159E01
  1. Remove the defogger relay from the engine room relay block.

  1. Disconnect the E36 air conditioning amplifier connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    Defogger relay terminal 1 - Body ground
    Engine switch on (IG)
    11 to 14 V
    Defogger relay terminal 5 - Body ground
    Always
    11 to 14 V

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    Defogger relay terminal 2 - E36-24 (RDEF)
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


10. CHECK HARNESS AND CONNECTOR (REAR WINDOW DEFOGGER - DEFOGGER RELAY AND BODY GROUND)
B185525E01
  1. Disconnect the S17 and S18 defogger wire connectors.

  1. Remove the defogger relay from the engine room relay block.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    S17-1 - Defogger relay terminal 3
    Always
    Below 1 Ω
    S18-1 - Body ground
    Defogger relay terminal 4 - Body ground
    S17-1 - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


11. CHECK REAR WINDOW DEFOGGER WIRE
B187440E01
  1. Disconnect the S17 and S18 defogger wire connectors.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    S17-1 (B) - S18-1 (E)
    Engine switch on (IG) and defogger switch on
    10 kΩ or higher



NG
REPLACE AIR CONDITIONING AMPLIFIER (Click here)
OK

REPLACE BACK WINDOW GLASS (Click here)

12. CHECK HARNESS AND CONNECTOR (DEFOGGER RELAY - BATTERY AND AIR CONDITIONING AMPLIFIER)
B188063E01
  1. Remove the defogger relay from the engine room relay block.

  1. Disconnect the E81 air conditioning amplifier connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    Defogger relay terminal 1 - Body ground
    Engine switch on (IG)
    11 to 14 V
    Defogger relay terminal 5 - Body ground
    Always
    11 to 14 V

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    Defogger relay terminal 2 - E81-38 (RDEF)
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


13. CHECK HARNESS AND CONNECTOR (REAR WINDOW DEFOGGER - DEFOGGER RELAY AND BODY GROUND)
B185525E01
  1. Disconnect the S17 and S18 defogger wire connectors.

  1. Remove the defogger relay from the engine room relay block.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    S17-1 - Defogger relay terminal 3
    Always
    Below 1 Ω
    S18-1 - Body ground
    Defogger relay terminal 4 - Body ground
    S17-1 - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


14. CHECK REAR WINDOW DEFOGGER WIRE
B187440E01
  1. Disconnect the S17 and S18 defogger wire connectors.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    S17-1 (B) - S18-1 (E)
    Engine switch on (IG) and defogger switch on
    11 to 14 V



NG
REPLACE AIR CONDITIONING AMPLIFIER (Click here)
OK

REPLACE BACK WINDOW GLASS (Click here)


← DATA LIST / ACTIVE TEST (from Sep 2011)Rear Window Defogger System does not Operate (from Jan 2012) →