2011-2013 Land Cruiser · Service Manual Vehicle Interior

INSTALLATION

Removal / installation · Vehicles built Sep 2011 – Dec 2011

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012


1. INSTALL ELECTRICAL KEY ANTENNA

  1. B180456
    Install the antenna with the 2 screws.


2. INSTALL REAR BUMPER ARM BRACKET LH

B181013
  1. Install the bumper arm bracket with the 2 bolts.

  1. Connect the connector.


3. INSTALL REAR BUMPER COVER

HINT:
For the rear bumper cover with tire carrier, use the procedures described below.

  1. w/o TOYOTA Parking Assist-sensor System, w/o Rear Fog Light:
    Attach the 14 claws to install the bumper cover.

  1. w/ TOYOTA Parking Assist-sensor System or w/ Rear Fog Light:
    Connect the No. 2 frame wire connector and attach the 14 claws to install the bumper cover.

  1. Install the 7 bolts, 6 screws and 2 clips.

    B188261

  1. Open the tail gate and install the 4 clips.

    B188260

  1. Close the tail gate.


4. INSTALL REAR NO. 1 BUMPER PLATE

  1. Attach the 20 claws to install the bumper plate.

    B188258


5. INSTALL REAR QUARTER PANEL MUDGUARD LH

B180882
  1. Install the mudguard with the clip.

  1. Using a T30 "TORX" socket, install the 6 screws.


6. INSTALL REAR QUARTER PANEL MUDGUARD RH

B180883
  1. Install the mudguard with the clip.

  1. Using a T30 "TORX" socket, install the 7 screws.


7. INSTALL SPARE WHEEL CARRIER SUB-ASSEMBLY (w/ Tire Carrier)
  1. Install the spare wheel carrier sub-assembly (Click here).


8. INSTALL PINTLE HOOK ASSEMBLY (w/ Pintle Hook)
  1. Install the pintle hook assembly (Click here).

← REMOVAL (from Jan 2012)INSTALLATION (from Jan 2012) →