2011-2013 Land Cruiser · Service Manual Vehicle Interior

Fuel Receiver Gauge Malfunction

Circuit diagnosis · Vehicles built Sep 2011 – Dec 2011

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012

DESCRIPTION

The fuel sender gauge has a variable resistance mechanism. The resistance decreases when the fuel amount increases, and the resistance increases when the fuel amount decreases. The fuel receiver gauge changes based on the resistance of the fuel sender gauge.

WIRING DIAGRAM

E197360E01

INSPECTION PROCEDURE


1. CHECK FOR DTC
  1. Check for DTCs (Click here).

    Result 
    Result
    Proceed to
    DTC B1500 or B1501 is not output
    A
    DTC B1500 is output
    B
    DTC B1501 is output
    C



B
GO TO DTC B1500 (Click here)

C
GO TO DTC B1501 (Click here)
A


2. PERFORM ACTIVE TEST USING INTELLIGENT TESTER (FUEL RECEIVER GAUGE ASSEMBLY)
  1. Operate the intelligent tester according to the steps on the display and select Active Test (Click here).

    Combination Meter 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Fuel Meter Operation
    Fuel receiver gauge
    EMPTY, 1/2 or FULL
    Perform the test with the vehicle stopped and engine idling.

    OK:
    Needle indication is normal.

    Result 
    Result
    Proceed to
    OK
    A
    NG (w/ Multi-information Display)
    B
    NG (w/o Multi-information Display)
    C



B
REPLACE COMBINATION METER ASSEMBLY (Click here)

C
REPLACE COMBINATION METER ASSEMBLY (Click here)
A

PROCEED TO NEXT INSPECTION PROCEDURE SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)


← Tachometer Malfunction (from Jan 2012)Fuel Receiver Gauge Malfunction (from Jan 2012) →