C1436 Yaw Rate Sensor Malfunction
Diagnostic trouble codes · Vehicles built from Jan 2012
DESCRIPTION
Refer to DTC C1419 and C1435 (Click here).| DTC Code |
DTC Detection Condition |
Trouble Area |
| C1436 |
Either condition is met:
|
Yaw rate sensor assembly |
WIRING DIAGRAM
Refer to DTCs C1232, C1243 and C1245 (Click here).INSPECTION PROCEDURE
- NOTICE:
- After replacing the yaw rate sensor assembly, perform calibration (Click here).
| 1. CHECK DTC (CAN COMMUNICATION SYSTEM) |
Check for DTCs (Click here).
Result Result
Proceed to
CAN DTC is not output
A
CAN DTC is output (for LHD)
B
CAN DTC is output (for RHD)
C
|
|
||||
|
|
||||
| A | |
| 2. READ VALUE USING GTS (YAW RATE SENSOR) |
Turn the ignition switch off.
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Chassis / ABS/VSC/TRC / Data List.
ABS/VSC/TRC Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
Yaw Rate Sensor
Yaw rate sensor/ Min.: -128°/s, Max.: 127°/s
Vehicle stationary: 0°/s
Right turn: -128 to 0°/s
Left turn: 0 to 127°/s
-
Check that the yaw rate sensor assembly output value is displayed on the GTS.
Result Result
Proceed to
NG
Yaw rate sensor assembly output value is 0°/s when vehicle is stationary, but value fluctuates when turning
A
Yaw rate sensor assembly output value is not 0°/s when vehicle is stationary
B
OK
C
|
|
||||
|
|
||||
| A | |
| 3. CHECK YAW RATE SENSOR ASSEMBLY INSTALLATION |
Turn the ignition switch off.
Check that the yaw rate sensor assembly is installed properly (Click here).
- OK:
- The sensor is tightened to the specified torque.
- The sensor is not installed at an angle.
|
|
||||
| OK | ||
| ||
