REMOVAL
Removal / installation · Vehicles built Sep 2011 – Dec 2011
Versions by build date: Sep 2011 – Dec 2011 from Jan 2012
| 1. REMOVE FRONT BUMPER COVER |
for Standard:
Remove the front bumper cover (Click here).
w/ Winch:
Remove the front bumper cover (Click here).
| 2. REMOVE NO. 4 ENGINE ROOM WIRE |
for Standard:
Remove the No. 4 engine room wire (Click here).
w/ Winch:
Remove the No. 4 engine room wire (Click here).
| 3. REMOVE NO. 1 ULTRASONIC SENSOR |
- HINT:
- Use the same procedure to remove the No. 1 ultrasonic sensor on the other side.
While pushing down on the lever with a finger to release the one claw, detach the claw on the other side to remove the ultrasonic sensor.

- HINT:
- The type of claw on the top and bottom of the sensor are different. Observe the claws carefully before removing the sensor.
| 4. REMOVE NO. 1 ULTRASONIC SENSOR RETAINER |
- HINT:
- Use the same procedure to remove the No. 1 ultrasonic sensor retainer on the other side.
Detach the 2 claws and remove the ultrasonic sensor retainer from the front bumper cover.

