2011-2013 Land Cruiser · Service Manual Audio / Visual / Telematics

INSTALLATION

Removal / installation · Vehicles built from Jan 2012

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012


1. INSTALL NO. 1 ULTRASONIC SENSOR RETAINER

HINT:
Use the same procedure to install the No. 1 ultrasonic sensor retainer on the other side.

  1. E244163E01
    Align the keyhole and protrusion as shown in the illustration.
    Text in Illustration 
    *a
    Protrusion
    *b
    Keyhole

    NOTICE:
    1. Do not damage the bumper with the protrusion when installing the No. 1 ultrasonic sensor retainer.
    2. Securely install the No. 1 ultrasonic sensor retainer so that there are no gaps between the retainer and surface of the rear bumper.

    HINT:
    The illustration shows the No. 1 ultrasonic sensor retainer for the RH corner. The vertical orientation of the No. 1 ultrasonic sensor retainers for the LH corner is opposite that of the image shown in the illustration.

  1. Attach the 2 claws to install the No. 1 ultrasonic sensor retainer.


2. INSTALL NO. 2 ULTRASONIC SENSOR RETAINER

HINT:
Use the same procedure to install the No. 2 ultrasonic sensor retainer on the other side.

  1. E244160E01
    Align the keyhole and protrusion as shown in the illustration.
    Text in Illustration 
    *a
    Protrusion
    *b
    Keyhole

    NOTICE:
    1. Do not damage the bumper with the protrusion when installing the No. 2 ultrasonic sensor retainer.
    2. Securely install the No. 2 ultrasonic sensor retainer so that there are no gaps between the retainer and surface of the rear bumper.

  1. Attach the 2 claws to install the No. 2 ultrasonic sensor retainer.


3. INSTALL NO. 1 ULTRASONIC SENSOR

HINT:
Use the same procedure for all No. 1 ultrasonic sensors.

  1. Attach the 2 claws to install the No. 1 ultrasonic sensor.

    NOTICE:
    Push the ultrasonic sensor retainer from the outside of the bumper when there is a gap between the retainer and the bumper surface. In this case, do not push on the ultrasonic sensor.


4. INSTALL NO. 2 FRAME WIRE
  1. for Standard:
    (Click here).

  1. w/ Towing Hitch:
    (Click here).

  1. w/ Pintle Hook:
    (Click here).


5. INSTALL REAR BUMPER COVER
  1. for Standard:
    (Click here).

  1. w/ Towing Hitch:
    (Click here).

  1. w/ Pintle Hook:
    (Click here).

← INSTALLATION (Sep 2011 – Dec 2011)COMPONENTS (from Jan 2012) →