INSTALLATION
Removal / installation · Vehicles built from Jan 2012
Versions by build date: Sep 2011 – Dec 2011 from Jan 2012
| 1. INSTALL DUCT TEMPERATURE SENSOR |
Attach the 4 claws to install the 2 sensors.


| 2. INSTALL REAR NO. 6 AIR DUCT |
Install the duct with the 5 screws.
Connect the 2 connectors.


| 3. INSTALL FRONT FLOOR CARPET ASSEMBLY |
Install the floor carpet.
| 4. INSTALL REAR NO. 1 SEAT PROTECTOR |
![]() ![]() |
Attach the 10 claws to install the 2 seat protectors.
| 5. INSTALL REAR NO. 2 SEAT PROTECTOR |
![]() ![]() |
Attach the 10 claws to install the 2 seat protectors.
| 6. INSTALL REAR SEAT COVER CAP (w/ Rear No. 2 Seat) |
w/ Sliding Roof:
(Click here)
w/o Sliding Roof:
(Click here)
| 7. INSTALL FRONT QUARTER TRIM PANEL ASSEMBLY LH |
w/ Sliding Roof:
(Click here)
w/o Sliding Roof:
(Click here)
| 8. INSTALL REAR SEAT COVER CAP (w/ Rear No. 2 Seat) |
w/ Sliding Roof:
(Click here)
w/o Sliding Roof:
(Click here)
| 9. INSTALL FRONT QUARTER TRIM PANEL ASSEMBLY RH |
w/ Sliding Roof:
(Click here)
w/o Sliding Roof:
(Click here)
| 10. INSTALL TONNEAU COVER ASSEMBLY (w/ Tonneau Cover) |
Install the tonneau cover assembly.
| 11. INSTALL REAR FLOOR MAT REAR SUPPORT PLATE |
w/ Sliding Roof:
(Click here)
w/o Sliding Roof:
(Click here)
| 12. INSTALL REAR DOOR SCUFF PLATE LH |
w/ Sliding Roof:
(Click here)
w/o Sliding Roof:
(Click here)
| 13. INSTALL REAR DOOR SCUFF PLATE RH |
w/ Sliding Roof:
(Click here)
w/o Sliding Roof:
(Click here)
| 14. INSTALL REAR NO. 2 SEAT ASSEMBLY LH |
for Face to Face Seat Type:
(Click here)
except Face to Face Seat Type:
(Click here)
| 15. INSTALL REAR NO. 2 SEAT ASSEMBLY RH |
for Face to Face Seat Type:
(Click here)
except Face to Face Seat Type:
(Click here)
| 16. INSTALL REAR NO. 1 SEAT ASSEMBLY LH |
for 60/40 Split Seat Type 40 Side:
(Click here)
for 60/40 Split Seat Type 60 Side:
(Click here)
| 17. INSTALL REAR NO. 1 SEAT ASSEMBLY RH |
for 60/40 Split Seat Type 40 Side:
(Click here)
for 60/40 Split Seat Type 60 Side:
(Click here)
| 18. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
- NOTICE:
- When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).
| 19. CHECK SRS WARNING LIGHT |


